105 SPIDER PARTS : OTHER INTERIOR PARTS

Gear lever vinyl gaiter - 5 rows of stitching with stitched finish at the base for cars without centre console, black.

Centre console inner fixing frame for the gear gaiter. To fit Spiders 1970-86

Centre console inner fixing frame for the gear gaiter. To fit Spiders 1987-93. 

Black right hand side B-Post trim panel to fit Spiders Roundtail. Made in plastic as per original. 

B post trim panel for Series 3 and Series 4 Spiders in tan/beige vinyl.

Black right hand side B-Post trim panel to fit Spiders from Kammtail to Series 3 models. Made in plastic as per original. 

B post trim panel for Series 3 and Series 4 Spiders in tan/beige vinyl, with two cutouts for boot and fuel flap release handles.

B post trim panel for Series 3 and Series 4 Spiders in black plastic as per original, with two cutouts for boot and fuel flap release handles.

Trim panel that sits down behind the left door opening on Series 2 Spiders and contains the boot release handle.  Made in plastic as per original. 

Left B post trim piece for all Roundtail Spiders. Contains a cutout for the boot release handle. Made in plastic as per original. 

Wire retaining spring clip to suit Spider inner door and window winder handles for cars 1966-72.

Pair of door armrest/handle plastic chrome trims/inserts. Fitted on 105 Spiders between 1978 to 1987 and Alfetta GTVs.

Interior door armrst/handle chrome insert. Fitted on 105 Spiders between 1978 to 1987

Rivets for holding down the stainless steel sill trims on all Spiders 1966 to 1993. These are 1mm oversize to allow for circumstances where the old rivets have been drilled out for removal. Now made of metal. See IN190 for standard size versions.

Rivets for holding down the stainless steel sill trims on all Spiders 1966 to 1993. These are standard size as per original and now made of metal. See IN190/1 for oversize versions.

Rubber clip for holding down the rubber boot (trunk) mats down in early Spiders from 1966-78. 22 are required in total for Roundtail cars up to 1970 and 11 for Kammtail versions from 1970 onwards.  

Interior drivers side door pull to suit all 105 Series Spiders 1966-78. Also used on 101 Series Spiders as well.

Passenger interior grab handle as fitted to the door trim of all Spiders 1966-1978. Can be fitted to either side - dependent on left or right hand drive.

Heater facia panel to fit Roundtail Spiders.

Set of pedal aperture finishing rubbers for carpet set. If you are having a carpet set made for your standing pedals Bertone GT these are essential to get the original look & prevent wear & tear to the carpet - set 4 covering the brake and clutch pedals,...

Courtesy light unit for inside the rear vision mirror on all Spiders 1966 - 82.  

Dynamat SuperLite is a high-efficiency sound dampening material used to stop noise and vibration in your automobile. It is the same sticky butyl rubber Constrain Layer Damper (CLD) as Dynamat Xtreme but in a 30% thinner, and lighter form. Use Dynamat...

Applying Dynamat to panels, doors eliminates panel distortion by transforming the flimsy sheet metal into a solid non-resonant baffle. Dynamat improves stops vibration rattles and squeaks. The Xtreme Bulk Pack controls vibration four times better than...

Sheets of the original style sound deadening material as fitted to most 105 Series vehicles. Sheets measure 50 x 100cm and are made of heavy duty bitumen style material with a thick felt backing. Price is per sheet.