750-234 BOOT/TRUNK & BONNET/HOOD STAY ROD BUFFER

Fuel flap buffer for all 105 series Coupe and Saloon models. Sold individually, two used per car. The cars should also be fitted with the rubber profile section available under code RB072 as...

Plastic profile moulding that fits around the edge of the guard inside the fuel flap to protect it from damage from the fuel filling hose. Often missing on most cars! Use in conjunction...

Small rubber grommet for the holes that the under bonnet/hood wiring passes through on many of the 105 series cars. Also fits the rear valance panel where wiring for the rear numberplate lights...

GT Junior, GTV Giulia saloon door buffer receiver - will fit left and right side. 1970 onwards, non step front cars. Please note, in some instances some early Step-front cars may have had a...

Pair of headlight wiring grommets to fit into the rear of the headlight bowl on all 105 Series Spiders 1966-93 and all Step-front GTs. Can also be used in the outer headlight bowls on some 1750 ...

Here is a diagram showing the location of some of the parts in this category.

Rubber seal that sits along the front edge/lip of the scuttle grille panel on all 105 Series GTs/GTVs.

Small profile rubber 'U' section seal used in a variety of locations on all 105 Series cars, plus some Giulietta models as well. Also used on S3 and S4 Spider, on the outer headlight ring...

Set of 8 rubber door bungs to fit all GTs, GTVs & GTCs to fill in the holes in the door frame - four used per door.

Here is a diagram showing the location of some of the parts in this category.