EX024 RUBBER HANGER FOR EXHAUST SYSTEM

Set of 2 metal plates and the insert forthe bolt hole on the rubber exhaust hangeron all 105/115 series cars. Two sets are required for each hanger, usually 4 per car (2 rubber hangers)...

A useful kit containing all the items you would normally need to fit a standard exhaust onto a 105 Series car. See also EX036 for replacement metal plates and inserts for the rubber hangers.

Replacement bush for the gearbox/exhaust hanger bracket that bolts to the gearbox on all 105 series cars and is usually affected by heat and oil! Two required per car.

Replacement middle exhaust section to suit all Giulia and Berlina saloons through the range to 1978and all GTs/GTVs up to 1970 with standing pedals, both left and right hand drive. For the...

Replacement exhaust tailpipe o-ring for the joint between the centre and rear sections of the exhaust on all 105 series cars

Here is a diagram showing the location of the parts in this category.

Front windscreen trim retaining clip.

Bracket gearbox - exhaust. For 105 series cars with standing pedals. Length 38mm.

High performance KN air filter for late air filter canisters on cars from 1969 to 1978. No need to ever replace it - just clean it and re-use. KN's replacement air filters are designed to...

Rubber/metal seal for the front upper wishbone bushes on early 750 Series models. 32mm OD and 24.5mm ID. Fits the upper wishbone bushes on the following 750 models (8 used per car): Berlina to...