EX058 BRACKET GEARBOX - EXHAUST UPPER

Replacement bush for the gearbox/exhaust hanger bracket that bolts to the gearbox on all 105 series cars and is usually affected by heat and oil! Two required per car.

Bracket gearbox - exhaust. For 105 series cars with standing pedals. Length 38mm.

Bracket gearbox - exhaust. For 105 series cars with hanging pedals. Length 32cm.

A useful kit containing all the items you would normally need to fit a standard exhaust onto a 105 Series car. See also EX036 for replacement metal plates and inserts for the rubber hangers.

Protective large rubber washer/spacer for the rear gearbox mount on all 105 series cars. Sits either side of the rear metalastic mount inside the gearbox crossmember. 2 washers required per car.

Gearbox rear mounting bush 2nd series - for all hydraulic clutch gearboxes - 1968-1993.

Genuine Bosch ignition coil (Bosch number 0221 119 027) as fitted to most 105 series cars. Will fit cars with Bosch or Marelli distributors.

Here is a diagram showing the location of some of the parts in this category.

Large rubber seal/gasket that fits between the transmission tunnel pressing and the transmission tunnel apeture cover (either metal or plastic/foam versions) on most of the 105 series range. Fitted...

Set of 2 metal plates and the insert for the bolt hole on the rubber exhaust hanger on all 105/115 series cars. Two sets are required for each hanger, usually 4 per car (2 rubber hangers)...