GB041 REAR GEARBOX MOUNT RUBBER WASHER

Gearbox rear mounting bush 2nd series - for all hydraulic clutch gearboxes - 1968-1993.

Small rubber gearbox seal. sits under the gear lever and on top of the metal plates on the rear 'tower' of the gearbox. Use in conjunction with the small washer available under code GB039/1.

Rubber gaiter that fits over the clutch actuating arm where it enters the gearbox bell housing on all mechanical clutch cars.

Large rubber seal/gasket that fits between the transmission tunnel pressing and the transmission tunnel apeture cover (either metal or plastic/foam versions) on most of the 105 series range. Fitted...

Reproduction rubber combination gearbox gaiter to suit 105 series cars from late 1960s onwards. Two part gaiter, with the inner section that attaches to the 'tower' at the rear of the...

Gearbox rear mounting bush (64mm diameter) to suit cable clutch 105 series cars up to 1967. Also fits 101 Series cars as well as 102 & 106 series 2000 & 2600 models - both in the...

Here is a diagram showing the location of some of the parts in this category.

Small metal washer that sits on top of the gearbox top seal (available separately under code GB039) and is retained by the gear lever.

Gearbox inner rubber gaiter. Fits over the rear 'tower' of the gearbox where the gear lever attaches to the gearbox on 101 and 105 Series 5 speed gearboxes. Fitted to all mechanical...

Original equipment Sachs 3 piece hydraulic clutch kit (pressure plate, friction plate and release bearing) - to fit all 105 Series cars 1968-1993 (excluding Montreals) ...