IN190 SPIDER SILL TRIM RIVET - STANDARD SIZE

Replacement rivets for holding down the stainless steel sill trims on all Spiders 1966 to 1993. These are 1mm oversize to allow for circumstances where the old rivets have been drilled out for...

Door panel retaining spring clip to suit all Spider door trim panels 1966-84. Use in conjunction with the clip receiver available under item code IN079.

Here is a diagram showing the location of some of the parts in this category.

Iinertia reel seat belt with special angle adjustable reel. We recommend static belts for cars without seat belt guides fitted to the side of the seat. Not suitable for S3 / S4 cars with...

Rubber clip for holding down the rubber boot (trunk) mats down in early Spiders from 1966-78. 22 are required in total for Roundtail cars up to 1970 and 11 for Kamm Tail versions from 1970...

Door panel clip receiver to fit all Spider door trims. This part fits into the door frame on all Spiders, quantity depending upon the model/year of the car. Used in conjunction with IN078 that...

Securon brand static front 3 point seat belt - fits all GT/GTVs and Spiders. These belts come with a 30cm (12 inch) long stalk to go against the transmission tunnel. If you want a 45cm stalk to fit a...

Inner stainless sill trim. All Spiders from 1966-93. Please note, on Series 4 cars this part was powder coated in black, even though it is exactly the same in appearance

The small plastic rivet that retains the top of door rain seals on all Spiders. One rivet is used on the rear of door glass seal (available under codes RB046 & RB046/1) and two on the front...

Here is a diagram showing the location of some of the parts in this category.