The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.
Montreal clutch kit. Consists of pressure plate, friction plate and release bearing.
Lens set for the Montreal with original Carello markings - full set including both left and right sides.
Clutch master cylinder (including reservoir) to suit Montreals. 7/8" (22.23mm) bore size.
Finally after many years out of production - correct clutch slave cylinder (longer body and longer push rod than regular 105 series one) for the Montreal. Also fits some (all?) Iso Grifo! This very...
Rebuilt Bosch starter motor to fit all Montreal engines. Please note this part is only available on an exchange basis. There is a £100.00 surcharge that we will refund you upon receiving back...
Inlet valve to fit Montreal engines. Sold individually.
Montreal wiper panel grilles pair.
** AWAITING NEW STOCK **
Parts kit for rebuild Montreal ZF gearbox.
Contains 5 bearings, 2 gaskets and 2 oil seals.
Taper style bearings. For the kit with ball style bearings, see MN094.
Montreal Gerbox syncro ring.
New alloy re-production of the original wheel fitted to the Montreal. 6.5 x 14 inch Campagnolo Millerighe, 4 stud with 108 PCD. Offset - ET23 Can also be fitted to GT or Spider models...
Replacement high quality water pump seal for Montreal.
New production of Junior Zagato perspex front headlight covers. With Carello markings. ** Please note the part shown in the photo has a protective plastic covering on it **
New production from the original manufacturer of top quality gearbox syncro rings to fit later 105 Series gearboxes, as well as later Alfetta and 75 based cars - including V6 versions. The best...
12mm lift, 290 degrees duration. Hollow billet lighweight camshaft, a good alternative to EN524 if you want better low end power with just a small amount less at the very top. Suitable for 2 litre...
Set of 5 50 cm x 30 cm sheets of gasket material of different grades/thicknesses. Ideal for making your own gaskets
High performance AP Sport clutch friction plate to fit hydraulic clutch cars 1968-93 with legendary AP race friction material and can be combined with the standard F&S pressure plate CL011.