The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.
Upper front wishbone bush to suit 101 Series cars. Two required per side, four per car. Approximate internal diameter 18.8mm. See 750-051 for the smaller bush for 750 series cars.
Lower wishbone bush to suit 750 Series cars. 2 per side, 4 in total per car. Approximate internal diameter 15.5mm. See 101-050 for the larger bush for 101 Series cars.
Rubber/metal seal for the front wishbone bushes on 1900, 2000 and 2600 cars as well as 750 and 101 Series models. 41mm OD and 30.5mm ID. Part number 1365.45.709 Fits the lower wishbone bushes on the...
Rubber/metal seal for the front upper wishbone bushes on early 750 Series models. 32mm OD and 24.5mm ID. Fits the upper wishbone bushes on the following 750 models (8 used per car): Berlina to...
Upper front suspension spacer for 750 & 101 Series cars. Approximate sizes I.D. 14.5mm, O.D.24mm and 2mm thick.
Protection cover for the fuel tank sender. Will fit all 105 Series cars. Please note this is made of black rubber, whereas the original type was made of a dense foam material and had an internal...
Ball joint, for the throttle linkage, works in conjunction with FL052/1.
Plastic throttle rod end, as per the original type on all Montreals.
LHD Throttle bell crank and bracket for Weber DCOE. High quality assembly machined from billet with replaceable pivot bushings. ONLY SUITABLE FOR LEFT-HAND DRIVE CARS.
Rubber strip to fit between the fuel tank and the surrounding bodywork, in the correct contour. Will fit all 105 cars
Accelerator return spring to suit all 105 model, GT Bertone, Spider and Giulia. Right or left hand drive.
Short vertical throttle rod (approx 97mm between centres) that fits between the carburettors on some Left Hand Drive 1750 and 2000 model 105 Series cars - and possibly some other versions too...
Earth strap to fit the carburettor mounts on all 105 Series carburettor cars. Often missing or damaged on many cars we see, ideal to replace when you fit new carburettor mounts.
Set of 4 individual solid aluminium carburettor mounts to fit 40mm carburettors but anodised in black to retain an original appearance to your engine bay. Machined from solid aluminium then fitted...
Non-locking bayonet style fuel/gas filler cap to fit all 750, 101 and 105 Series cars with bayonet style fuel filler necks from 1955-1972 and GT Junior until 1977. Includes the rubber seal. All 2000...