Grommets for air ducting tubes, pair
The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.
Hot air ducting tube (60mm diameter) to suit all 105 series cars from 1970 on with the 'warm air' intake panel located on the side of the engine block. This tube goes from the air cleaner to the...
750 and 101 Series Spider fuel filler aperture grommets - sold as a pair (2 required per car).
Correct original style 35mm diameter spiral bound heater ducting hose to suits most 750 101 series cars. Sold in 1 metre lengths.
80mm diameter fresh air ducting hose to suit 750 101 Series Spiders and Sprints. This is 80 cm long approximately. Used on both sides of car on Sprints and Spiders except for 101 1600 Normale...
80mm diameter fresh air ducting hose. This part is 60 cm long approximately and is used on one side of the 101 Series 1600 Spider for fresh air ducting and may also be used on other models as...
Hot air ducting tube (60mm diameter) to suit all 105 series cars from 1970 on with the 'warm air' intake panel located on the side of the engine block. This tube goes from the air cleaner to the...
Handbrake lever buffer. See second pictures for fitting position.
Vertical door glass channel felt for the 750 101 cars with a metal spine like the original type. Two sizes available ( see pictures ) 15mm and 12mm part 750-253. Sold by the metre.
Side air vent hose for late GT Junior / 2000GTV dashboard (goes to the back of the "eyeball" vents). Two per car.
Fantastic production of the later style of interior courtesy light lenses as used in 2000 GTVs, late GT Juniors, 2000 Berlinas and late Giulia saloons. Includes the 'clear' section for increased...
Rubber dash vent hose (11 cm long) that fits between the heater and the centre dash top vents on all 105 Series GTs/GTVs with the later style heater used from about 1968 onwards. Two used per car.
Pair of air filters to fit the intake system of US specification SPICA mechanical fuel injection 4 cylinder cars. Filters approx 185mm long and 90mm diameter each.
Rubber buffer to fit onto the end of the bonnet/hood support stay on 750 & 101 Series Spiders and all Stepfront Coupes and the boot/trunk support stay on all 750/101 Spiders as well as...
Pair of rubber seals for where the base of the wiper arm meets the bodywork of the car on all 750 101 Series.
Grommet for throttle linkage on 750, 101, 102 (2000) and 106 (2600) Series cars.