FISPA decal to fit on the top of the air box, normally used on 105 series cars, using air filter EN051.
The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.
Rubber seal to fit into the original engine bay Fispa fuel filter/pressure regulator unit fitted to 750, 101 and 105 Series cars. This filter unit uses the smaller 3.3cm diameter filter FL005...
Small curved FISPA decal to fit on the top of the large oval shaped 'crossover' style air filter unit found on most 105 Series cars to about 1970.
Gasket to fit the crossover style aluminium air filter housing fitted to all twin carburettor 105 Series cars 1300 to 1750 up to 1969. Fits between the lid and the body of the housing that bolts...
FISPA oil filter decal for 750 Series, 101 Series, 102 Series (2000) Series cars.
Air filter to fit the single carb FISPA cannister setup mainly found on early 105 Series Giulia Saloons. H11cm D13cm ID9cm
Small curved FISPA decal to fit on the top of the large oval shaped 'crossover' style air filter unit found on most 105 Series cars to about 1970.
FRAM decal to fit on the top of the air filter unit found on most 105 Series cars from approx 1969 onwards. Long cylindrical air box, attached next to the carburettors.
Paint code stickers - please select the paint code number you require from the drop down menu .
Red sticker for rad cap
Cylindrical Air filter - later type (105.48) - length 41cm x 12 cm diameter to suit later 105s with the filter on the carb side plus some 116 models. Please check measurements before ordering!
Spica fuel tank to fit USA 2000 GTVs - 55 litre. Please note, this tank is not suitable for cars equipped with carburettors If you require a fuel tank for a carburettor GTV, please see FL041
Montreal Centre Heart, chromed.
Bilux 7" headlamp with original style Carello font and built in sidelamp (with 3 rear locating lugs) to suit Left Hand Drive 750 101 Series cars that drive on the right side of the road. Also...
Door mirror - round style. Fits either side of the car with mottled insert / pattern on base. Base size approx 10.8 x 2.1cm. 93mm hole spacing. This mirror is a slightly smaller diameter than the...
Front seat back lower fixing trim, to suit 1750 GTV & 2000 GTV models.