Categories

105.08 body type plate to suit Giulia TI saloons, 1964-1967.

Rubber plug brake master cylinder, 15mm diameter. Used to connect the reservoir to the master cylinder.

Rubber plug brake master cylinder, 20mm diameter. Used to connect the reservoir to the master cylinder.

Zagato 'Z' badge as found on Junior Z.

Chromed hubcap for all 750 & 101 series cars with black and silver centre badge. Small back opening to fit over spring clips mounted near the wheel stud holes.

Reservoir cap to fit the left hand drive clutch master cylinder reservoir. This cap will also fit the brake fluid reservoir on right hand drive 105 Series cars 1968 onwards and left hand drive cars 1968-70 with hydraulic clutch and single...

Oil pump pick up spring clip.

Steering idler box repair kit, containes two bushes one 5mm, one 2mm and shaft. To fit 101 Series cars 1958-64. If you require other type of bush combination, please contact us.  

115.02 body type plate Spider USA Kammtail left hand drive models, 1971-1982.

105.91 body type plate Spider Junior left hand drive models, 1968-1973.

105.03 body type plate 1600 Roundtail Spider left hand drive models. 1966-1967

105.57 body type plate Spider Veloce 1750 left hand drive models, 1967-1971.

105.24 body type plate Spider Veloce left hand drive models, 1971-1982.

Reproduction 1750GTV & GTAm side grilles, made in aluminium. The mesh pattern is slightly larger than the original design (improved airflow for extra cooling!). The small plastic "egg timer" grilles are available separately under our part number CH010.

Synchro ring - grooved type for early gearboxes to fit 750, 101, 102, 106 (2600) and early 105 Series gearboxes (cars with a mechanical clutch).

Rear light lens seals, will fit either left or right side. Between the lenses and the light backing on a Kammtail Spiders 1970-84 Price is for one seal. 

105.39 body type plate to suit left hand drive Giulia Ti 1300, 1965-1972.

Rotor arm to suit 8 plug GTA distributor with 10mm shaft, usually found on 1300 GTAs and some 1600 cars.

Inlet manifold gasket to fit all early carburettor 101 and 105 series cars. For later carburettor cars see code FL022 and for later Fuel Injected cars see FL039.

Jim Evans valve spring kit - for use with our 1300 / 1500 valves with a 9/32" stem. Under extreme use some competition valve springs can bind their inner and outer springs - these will not.

OE quality SKF propshaft centre bearing for all 750, 101, 102 Series 2000, 106 Series 2600  and 105 series cars, including Montreals plus 4 cylinder 116 and 75 models. Inside diameter 30 mm, OD 62 mm, width 16 mm. Features metal shields optimised for...

2MM bush to suit 101 series steering idler boxes. Will also fit later 750 series cars, approximately 1958 onwards. Bush approx. 24mm ID and 28mm OD. These bushes need reeming to suit your existing pin. Also used on 2000/2600. You need to order two bushes...

Repair section for the top of the right rear wing under the side window. A common place for these cars to rust! Fits all GT / GTV - 1964-77.

Repair section for the top of the left rear wing under the side window. A common place for these cars to rust! Fits all GT / GTV - 1964-77.