Categories

Outer chromed Gt Junior seat screw. Beautifully made.

Gt Junior seat adjusting knob. Beautifully made in solid aluminium and then powder coated.

Right seat lever end knob, to suit Mk2 1750 GTV.

Left seat lever end knob, to suit Mk2 1750 GTV.

Right seat lever end knob, to suit 2000 GTV.

Left seat lever end knob, to suit 2000 GTV.

Engine mount and metal frame for the right (intake) side of the engine. This is the engine mount with the squared rubber block. If you require the round type please see EN062.

Engine mount and metal frame for the left (exhaust) side of the engine. This is the engine mount with the squared rubber block. If you require the round type please see EN061.

GT window clamp. Used in conjuction with a cable window regulator. Fits at the bottom of the door glass and clamps the cable from the window winder cable. If you also require the window regulator please see GL007 GT CABLE WINDOW REGULATOR -...

Exhaust clamp to suit all standard sized (51mm) 116 and 75 series exhaust systems (not V6). Usually one clamp per car, located on the join between the centre and rear exhaust mufflers.

Exhaust clamp to suit all standard sized (48mm) 116 and 75 series exhaust systems (not V6). Usually one clamp per car, located on the join between the centre and rear exhaust mufflers. This clamp also fits Montreals on the join between the front and...

New long left hand drive Burman steering box. 69.5cm length, see pictures for more detail. ** NOTE ** - Before ordering double check the size of your current steering box, as Alfa produced two long sizes.

Screw for the front quarterlight hinge on all GT cars. This is the screw that goes through the glass from the inside of the car to mount the lower half of the quarterlight hinge.

Front seat back lower fixing trim to suit all GT Junior seats from 1966-72 (seats without a headrest).

Metal glovebox for all Giulietta Giulia Spider 750 101 cars.

Burgundy/Bordeaux vinyl cover for the rear shelf/seat area on a Roundtail spider. Please note this cover is stitched and padded to give it a more luxurious feel. Unlike the original which was heat stitched and single layered. Comes with...

Burgundy soft-top cover (hood bag) to suit Spider 1970-89. Clips over polished trim at the back of the hood and attaches down in front of the folded roof. All clips included. If you need some extra vinyl please see IN301 for the same...

Pair of front air ducts to fit 750 & 101 Giulietta Spider Veloce. This is a very well made panel and being handmade, supply can be very sporadic.   

Pair of front air ducts to fit 750 Giulietta SPRINT Normale. This is a very well made panel and being handmade, supply can be very sporadic.  

Dash vent for for Spider 750 & 101 cars.

Seat adjuster chrome trim, to suit mk2 1750 GTV & 2000 GTV. Stainless steel. 67mm diameter 

Seat adjuster chrome trim, to suit Spider 1300-2000 and mk1 1750 GTV. Stainless steel. 68mm diameter 

Front seat back lower fixing trim, to suit 1750 GTV & 2000 GTV models. 

Right GT door glass guide, rear of door. Bertone GT.