CL009/1 CLUTCH RELEASE BEARING - ORIGINAL SACHS

Aftermarket hydraulic clutch release bearing to fit all hydraulic clutch 105 Series Alfas including Montreals.

Original equipment Sachs 3 piece hydraulic clutch kit (pressure plate, friction plate and release bearing) - to fit all 105 Series cars 1968-1993 (excluding Montreals) ...

Retaining clip required to fit the newer design clutch release bearing available under item code CL013 to all mechanical clutch cars. Two required per car.

Spring to fit all 105 Series hydraulic clutch release bearings 1968-1993.

Clutch release Bearing Adapter for 750/101 105 Cars. This adapter is designed to allow the use of a 1750/2000 engine and clutch in a 750, 101 and 105 models with a mechanical clutch. The car...

Large rubber seal/gasket that fits between the transmission tunnel pressing and the transmission tunnel apeture cover (either metal or plastic/foam versions) on most of the 105 series range. Fitted...

Protective large rubber washer/spacer for the rear gearbox mount on all 105 series cars. Sits either side of the rear metalastic mount inside the gearbox crossmember. 2 washers required per car.

Small rubber gearbox seal. sits under the gear lever and on top of the metal plates on the rear 'tower' of the gearbox. Use in conjunction with the small washer available under code GB039/1.

Gearbox rear mounting bush 2nd series - for all hydraulic clutch gearboxes - 1968-1993.

Reproduction rubber combination gearbox gaiter to suit 105 series cars from late 1960s onwards. Two part gaiter, with the inner section that attaches to the 'tower' at the rear of the...