Thackery washer, carburettor mounting. 5/16 - M8 fitting.
The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.
Sump plug washer for most 750/101/102/106/105 series twin-cam engines. We supply copper or aluminium depending on availability from our suppliers - both work equally well. We recommend you...
Conrod nut. Two required per conrod, 8 in total per engine. 1600-2000 engines only, including TS. We recommend you replace any tab washer once it has been used more than once.
Camshaft to chain sprocket tab washer. Two required per engine. We recommend you replace any tab washer once it has been used more than once.
Washer bag with cap to fit 105 series cars from 1970 onwards, with the foot washer pump. Distance of eyelets from centre to centre 125mm
Washer bag cap to fit washer bags WI006 WI007.
Set of 4 individual solid aluminium carburettor mounts to fit 40mm carburettors but anodised in black to retain an original appearance to your engine bay. Machined from solid aluminium then...
Siamesed carburettor rubber centre mount and two individual to suit 40mm carburettors. This mount replaces the two separate central mounts and bridges between the two carburettors. These must...
Set of 4 individual solid alloy carburettor mounts to fit 45mm carburettors. Set includes 'O' rings , thackery washers and nylock nuts for the carb side plus plain nuts for the inlet manifold side...
Carburettor rubber mount to suit 40mm Weber, Dellorto and Solex carburettors. Used on all 105 series GT/GTV, Saloons and Spiders as well as 101 Series Veloce cars. Normally 4 required per car, but...
Mechanical fuel pump to fit all carburettor-equipped 105 series cars plus 101 series 1300 and 1600 Normale cars. Mounting gaskets and plastic spacer blocks are available separately. This...
Earth strap to fit the carburettor mounts on all 105 Series carburettor cars. Often missing or damaged on many cars we see, ideal to replace when you fit new carburettor mounts.
Adjustable throttle rod. Replace your old worn out horizontal plastic rod and make sure you are getting full throttle travel! Vertical rod also available - see item code FL051/1 Metal ends...
Viton fuel resistant rubber O ring to suit all solid carburettor mounts - as we have available under item codes FL017 and FL018. Ideal if you lose or damage an O-ring when fitting.
Carburettor rebuild kit to suit Weber 40 DCOEs - kit does 2 carburettors
Short vertical throttle rod (central aduster threaded rod is 45mm) that fits between the carburettors on twin carburettor 101 and 105 series cars. Includes metal ends and spring retaining...