High tension spark plug lead set. With long king lead to suit 105 series cars with the coil located on the bulkhead and most 4 cylinder 116 models. 7mm wire.
Not silicone, if silicone is required, see IG003/1
The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.
High Tension spark plug lead set - to fit earlier 105 Series cars with a short king lead for cars with coil located next to the distributor. In wire wound red silicone. 7mm wire.
High tension spark plug lead set. Wire wound silicone with long king lead to suit 105 series cars with the coil located on the bulkhead and most 4 cylinder 116 models. 7mm wire.
High tension spark plug lead set in green. To suit earlier cars with the shorter coil lead for cars with the coil mounted near the distributor, with a 7mm wire.
High tension spark plug lead set to suit Left Hand Drive Montreals. Please enquire for right hand drive versions.
HT lead set for 75 twinspark.
High tension spark plug lead set. Wire wound silicone with long king lead to suit 105 series cars with the coil located on the bulkhead and most 4 cylinder 116 models. 7mm wire.
High tension spark plug lead set in green. To suit earlier cars with the shorter coil lead for cars with the coil mounted near the distributor, with a 7mm wire.
Performance Lumenition silicone spark plug lead set with short (12 inch/310mm) coil king lead for earlier (pre 1968) cars with the coil mounted down near the distributor. Leads have a 100%...
High Tension spark plug lead set - to fit earlier 105 Series cars with a short king lead for cars with coil located next to the distributor. In wire wound red silicone. 7mm wire.
Performance Lumenition silicone spark plug lead set with long coil king (36 inches/910mm)lead for later cars with the ignition coil mounted on the bulkhead. Leads have a 100% silicone translucent...
High tension spark plug lead set to suit earlier 105 cars (1964-67) and all Giuliettas 750 & 101 (1955-1963) with the ignition coil mounted near the distributor in the engine bay. Produced...
Cross-over induction air hose for Bosch injected Spiders 1982-93. It goes from the air flow meter housing across the engine to the plenum chamber. If you require the hose clip for this...
Ideal for use with the Pertronix Electronic Ignition kits available separately, as well as anyone seeking a high performance ignition coil. Black body, 3.0 ohm. Suitable for standard and fast road...
Rubber seal in the correct style for all Spiders 1970-93 - with a flocked/velour edge. 2 required per car. See item RB022 for the matching seal for Roundtail Spiders. Also see item RB023 for...
Courtesy light unit for inside the rear vision mirror on all Spiders 1966 - 82.