NEW PRODUCTS

Carbon fibre bonnet to suit 105 series stepfront GTs. If you are looking for a super lightweight alternative to your current steel bonnet, whilst also retaining the strength and rigidity of a steel panel. Then look no further. This carbon fibre...

Carbon fibre boot lid to suit all 105 series GTs & GTVs. If you are looking for a super lightweight alternative to your current steel boot lid, whilst also retaining the strength and rigidity of a steel panel. Then look no further. This carbon...

Remanufactured radiator to suit all 116 GTV6s.

Rear left outer wheel arch to suit all Alfa 75s.

Rear right outer wheel arch to suit all Alfa 75s.

Lower front spoiler right and left to suit Alfetta GTVs. These panels are made out of fibreglass.

Bonnet/hood trim piece to suit all Giulia Nuova Supers. This is the trim piece that sits on the front lip of the bonnet just above the grille.

Chrome interior light switch cover to suit 105 series Giulias Berlinas.

Clutch release bearing to suit 1900/102 series cars. This is the bearing only (not the carrier). Please check the dimensions of your current bearing against the dimensions below as there were some variations on release bearings used over the years...

High tension black spark plug lead set to suit Left Hand Drive Montreals. - 7mm Silicone wire.

Plastic wiper shaft spacer to suit 105 series 2 Spiders from 1970-83.

Goodridge braided brake line set (complete car set – 3 pieces) to suit GTV6s 75s. These stainless steel brake flexi hoses will improve the pedal feel and are guaranteed for life. They also feature an anti-corrosion protective coating. For use...

Propshaft centre joint to suit all 1900 series cars. This is a special order only product and will normally take 5 days for delivery. Please contact us if you would like to order info@classicalfa.com If you also require the universal joint please...

Rear anti-roll bar Super-Flex polyurethane mounting bushes (23mm diameter) to suit late plastic bumper Alfettas.

Rear anti-roll bar Super-Flex polyurethane mounting bushes (22mm diameter) to suit Alfettas.

Rear anti-roll bar Super-Flex polyurethane mounting bushes (20mm diameter) to suit Alfettas.

Front anti-roll bar mounting polyurethane bushes (20mm diameter) to suit early Alfetta GTVs. These are the earlier style mounting bushes that have the flanges on the flat side of the bush.

Front torsion bar brace mounting kit to suit all 116 Alfettas. This kit contains the 2 bushes needed to mount the torsion bar brace. Made from long lasting SuperFlex polyurethane!

Centre console switch panel fascia to suit all Montreals. This is a premium quality production made out of metal and finished with a lovely textured surface.

Column switch to suit 4 cylinder Alfetta GTVs as well as Alfetta GTV6s. Please note this is the European version of the column switch so will not be suitable for USA cars.

Aluminium sunvisor support to suit 750 101 series Sprints. This bracket is reversable so will fit both sides.

Throttle linkage bracket to suit 750/101 series Sprints & Spiders.

Ignition lead clamp to suit 750/101 series Sprints and Spiders. This clamp replaces the original style clamp that was part of the jubilee clip onto the inlet manifold.

Washer bag bracket to suit all 750/101 series Sprints as well as Sprint Speciales.