The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.
Complete rear valance panel in aluminum to suit GTAs.
Rear panel boot latch inner frame - y piece. For all GT and GTV models.
Nice quality GTA/Stepfront front panel in aluminium. Stamped from a tooling, not a handmade approximation! Requires the two oval holes to be cut out under the main grille apeture to match...
Complete right side aluminium rear wing/fender. Stamped from accurate tooling - not a hand-made approximation. Uses the later higher arch profile (post 1967) as used on 1300 GTA style...
Reproduction aluminium panel that covers the area between the rear screen and the top lip of the bootlid. Matches into the rear wings.
High performance race-spec clutch with rigid sintered fricton plate and lightweight steel flywheel set to suit cars fitted with mechanical clutch cars. 105 teeth ring gear / 6 bolt crank. Suitable...
6.5x15" GTA wheel suitable for 105 GT & Spider cars. By using a 6.5" width but with the more dished front profile of the 7" GTA wheel we avoid problems of the wheels fouling on the bodywork. This...
Top quality high compression piston complete with piston rings, gudgeon pin and circlip. 11.8:1 compression ratio. Price is per piston. 80mm to fit standard liners. Small end of conrod may need...
Extra low boot/trunk lid rubber seal designed for racing GTA or GTV's or for anyone having issues with their bootlid closing enough on it's seal.
Set of original 2000 high compression (10.4:1) pistons & liners. Set includes Goetze piston rings, gudgeon pins and circlips. Will fit 105 / 116 series engines (Not TS). Can be purchased individually...
New 2000cc cylinder liner that has been precision bored in a special jig to increase capacity to 84.5mm to suit our special high compression Cosworth race pistons - available separately under item...
Specially produced lightweight 45 amp output alternator. Designed to fit onto the exisiting mount and bracket on all alternator equipped 105 series cars. Includes a built in voltage regulator - very...
Pair of new aluminium ATE front brake calipers to suit GTAm cars.
2000 COSWORTH FORGED RACE PISTON - 84.5mm bore. New design from leading UK Alfa competition engine builder Jim Evans, available only from Classic Alfa. Suitable for all performance 2000 engines &...
Big brake conversion kit for 1750/2000 cars (cars fitted with 89mm caliper spacing steering uprights). This fantastic kit comprises lightweight 4 pot calipers etched with our cloverleaf logo, vented...