The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.
Screw for fixing the GT door hinges. Early cars had a pozi head screw like this (although the originals are slightly domed and ours are flat).
Radiator top hose with large diameter end to suit all cars with inlet manifolds fitted with screw-in thermostats. Also fits some 101 Series Veloce cars with the 'screw in' thermostat housing. See...
Rear reflector for early type rear lens - 1964-1971 GT / GTV and all GT Junior 1966-77 (except South African Juniors with large rear lights). Dimensions: Studs (centre to centre distance) -...
Synchro ring - grooved type for early gearboxes to fit 750, 101, 102, 106 (2600) and early 105 Series gearboxes (cars with a mechanical clutch).
Black high tension spark plug lead set. Wire wound silicone with short king lead to suit 105 series cars with the coil located on the inner wing. 7mm wire. If you need to replace the HT lead rubber...
Original style gearknob - screw on style - as fitted to 750 Series cars with Borg Warner Gearbox.
Quality Italian leather gear lever gaiter - 5 rows of stitching with stitched finish at the base for cars without centre console, black. This gaiter is for the Alfa owner that wants to treat...
Beautifully made grey pair of inner door panels to suit all Sprint GTs and GTVs as well as GT Juniors and 1750 GTV Mk 1 models. Done in the correct style and material.
Carpet set to suit all left hand drive Bertone 1750 GTV mk1 from 1967-69. Produced in the correct orginal style and grey colour . See also item code IN311 for right hand drive Mk 1 1750 GTVs with...
Armrest support plate. Suitable for GT 1300, 1600 & 1750 (with plastic door handles) & Giulia saloon 1300, 1600. Will do both right and left door. Please note early GTs with foam door...
Mechanical fuel pump for 105 and 116 series carb engines with outlets to the top and side.
12V ignition coil for 750, 101 and 105 series cars and 4 cylinder carb-equipped 116 and 75 models. NGK products are known for reliability!
FISPA decal to fit on the top of the air box, normally used on 105 series cars, using air filter EN051.
Retaining clip required to fit the clutch release bearing available under item code CL041 (rounded ends). Two required per car.
Set of gear gaitor trim clips. Used to hold the gear lever vinyl gaiter in place.
Gear gaiter base, GTV & late Juniors with centre console. Please note, you will need to drill the fixing holes on the cover. We understand that the early MK1 1750 was not fitted with this...