Coolant hose from water pump to thermostat to radiator overflow container to fit fuel injected Spiders 1989-93 with electric engine fans.
The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.
Bottom radiator hose to fit fuel injected Spiders 1989-93 with electric engine fans. Not suitable for cars with AC
Cross-over induction air hose for Bosch injected Spiders 1982-93. It goes from the air flow meter housing across the engine to the plenum chamber. If you require the hose clip for this...
Standard exhaust manifold to suit Bosch injected Series 4 and late Series 3 Spiders 1989-93. This manifold replaces the outer (cylinders 1 4) manifold that can crack in some circumstances...
Water pump to thermostat hose to fit fuel injected Series 3 Spiders 1986-89 with engine driven radiator fans.
Hose which runs from the T-piece to the water pump on 75 4-cylinder fuel injected models.
Inlet manifold outlet for the heater hose 10mm.
Exhaust manifold nut to suit 101, 105, 116 and 75 engines, including V6. 8 fitted per cylinder head. These are a smaller outer diameter than the original which makes tightening easier as you have...
Moulded heater hose shaped to suit the later heater unit as found in Kammtail/Series 2 Spiders, 1750/2000 GTVs & GT Juniors and Giulia and Berlina Saloons from about...
Top radiator hose to fit Bosch fuel injected Spiders from 1989-93.
Water pump to fit Bosch fuel injected Spiders 89-93 with thermostatically driven/electric fans plus some 4 cylinder 116 and 75 models with injection and electric fans. Please compare pictures...
Athesil RTV silicone sealant. A premium sealant/ gasket maker developed by Athena for professional use in engine maintainace and repair. The RTV (room temperature vulcanizing) silicone seals plastic...
Silicone bypass hose to suit all 3 outlet waterpump cars from about 1970 through to 1987. Goes from the water pump to the bottom of the inlet manifold underneath the thermostat housing.
Lower mounting rubber for the raditator on all Series 4 Spiders 1990-93.
Set of six 'washers' (four fibre, two aluminium) for the cam/valve cover hold down bolts on all 101, 105, 116 and 75 engines (excluding Ts and V6). The same washers are also used on Montreal engines...
Copper cylinder head to exhaust manifold gasket to suit all 101 and 105 series engines plus 4 cylinder 116 models and 4 cylinder 75 engines (not TS).