The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.
Inner gear lever gaiter 750 cars
Montreal gear lever gaiter, done in the correct black Skai vinyl, as per original.
Rubber gear gaiter for the transmission on all 750 Series cars. Fits over the opening in the transmission tunnel in the interior of the car.
Handbrake lever button. Please note the pilot hole has been drilled, but will require finishing by customer for the correct pin diameter (it is made as a low volume 3D printed part).
Differential pinion inner (Rear) bearing to fit all 750 series cars. High quality bearing.
New production of the chrome gear lever gaiter frame that fits all 1750 GTV centre consoles. Excellent quality and even includes the cast Alfa part number.
Large rubber seal/gasket that fits between the transmission tunnel pressing and the transmission tunnel apeture cover (either metal or plastic/foam versions) on most of the 105 series range. Fitted...
Rubber gaiter that fits over the transmission tunnel aperture cover (that attaches to the transmission tunnel pressing) inside the cockpit of all 105 series Coupes, Saloons and Spiders...
Gearbox inner rubber gaiter. Fits over the rear 'tower' of the gearbox where the gear lever attaches to the gearbox on 101 and 105 Series 5 speed gearboxes. Fitted to all mechanical...
Grommets for air ducting tubes, pair
Grommet for throttle linkage on 750, 101, 102 (2000) and 106 (2600) Series cars.
Gearbox rear mounting bush (48mm diameter) to fit 750 and early 101 four speed gearbox.
Set of 4 radiator support rubbers to suit 1900, 750, 101 and 106 Series cars.
Pair of 750/101 Spider door rubber buffers/stops. Also fits 2000 (and 2600?) Touring bodied Spiders as well.
Outer door handle seals set to suit all 750 & 101 Series Sprints, Spiders & Berlinas.