Useful tool for bending new brake lines to fit onto all Alfas - as well as other lesser marques.
The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.
Rubber grommet for the inner guard/wing where the hydraulic brake pipe passes through the metalwork. Two required per car - one on each side. Also fit Montreal bonnet emergency release cable and the...
Short front brake pipe from the flexible line to the brake caliper on ATE braked cars from 1968-93 with large front calipers (1750+2000 models) including Montreals. Please specify if you require...
Fantastic tool for straightening new brake lines to fit onto all Alfas - as well as other lesser marques. Allows you to create dead straight pipe runs for a factory finish look. For 3/16" pipe...
Short front copper brake pipe from the flexible line to the brake caliper on all Dunlop braked cars from 1964-66.
Cupro-nickel short front brake pipe from the flexible line to the brake caliper on ATE braked cars from 1968-93 with large front calipers (1750+2000 models) including Montreals. If you require...
Fantastic tool for straightening new brake lines to fit onto all Alfas - as well as other lesser marques. Allows you to create dead straight pipe runs for a factory finish look. For 3/16" pipe...
Steel spring clip to fit the dust seals on the 38mm diameter piston ATE rear brake calipers fitted to all ATE braked 105 series cars from about 1967 onwards. Should be used in conjunction with the...
Caliper seal kit to fit all ATE rear brake calipers - one kit does two calipers. Note, if you are splitting the caliper apart, this kit does not include the small internal 'O' rings in the calipers...
Brass male brake union - 3/8 UNF thread - to suit the braking system on all 105 series cars except for the caliper fittings. See item code BR321 for the union to fit into ATE brake calipers...
Brake line set to suit right hand drive 1750 Mk2 & 2000 GTVs and late GT Juniors fitted with twin brake servos - except for the front brake pipe to the calipers on GT Juniors and the main...
Goodridge braided brake line set (complete car set – 3 pieces). These stainless steel brake flexi hoses will improve the pedal feel and are guaranteed for life. This version is approved by the...
Rebuild kit to suit all rear ATE brake calipers, including new pistons and seals. With a piston diameter of 38mm this kit will suit all ATE rear calipers from 1967 onward. Note that the pistons...
ATE brake cylinder paste is used for repair, assembly and conservation of hydraulic brake components, It is applied thinly and evenly to cylinder sleeves, pistons and seals. (Assembly of...
Handbrake lever assembly to fit the handbrake mechanism on ATE braked cars where the cable attaches to the handbrake mechanism.
Sealing ring (approx 45mm OD) that fits between the steering idler and steering arm on 750, 101, 102 (2000), 106 (2600) and 105 Series cars. May also be fitted between the steering box...