Categories

Gearbox mainshaft rear bearing to suit hydraulic clutch gearboxes. Inside diameter 25mm, outside diameter 52mm, width 15mm.

Mainshaft rear bearing to suit mechanical clutch 105 series cars. Also fits 102, 106, 750 and 101-series cars but check sizes. Inside diameter 25mm, outside diameter 52mm, width 15mm.

Mechanical clutch pressure plate to suit 750, 101 and early 105 series cars. Use in conjunction with the friction plate available under item code CL015 and the release bearing and retaining clips available under item codes CL013 and CL013/1.

Mechanical clutch friction plate to suit 750, 101 and early 105 series cars. Use in conjunction with the pressure plate available under CL016 and the release bearing and retaining clips available under item codes CL013 and CL013/1.

Heater motor with fan. Approx.16.5cm diameter fan and a base fitting measuring 85mm (see photo). To fit the earlier style heater unit (pre 1968) found on Sprint GT/GTVs and 1600 Roundtail Spiders. Also used on early Giulia saloons 1963-67.

Complete side grille set (left and right) for 2600 Spider.

New original Bendix brake servo to suit all ATE RHD cars and LHD cars with standing pedals. If you require the unions, please click on the link below. You will require two per servo: - BR323 BRAKE UNION 3/8 UNF MALE

Plastic chrome edge trim for the 2000 GTV, 1750 & 2000 Berlina armrest. Please note, this differs slightly from the original type by having a self-adhesive backing. Also, please ensure surface is thoroughly cleaned before fitting.  Sold in 1 metre...

Inlet valve guide to fit 2600 engines.

Valve guide to fit both inlet and exhaust valves on 102 Series 2000 engines as well as exhaust valves on 106 Series 2600 engines.

Plastic chrome edge trim for the centre console on 1750 GTVs and Berlinas and some Giulia Supers as well as the 2000 GTV and late GT Juniors with centre consoles.  It also is used on the armrests/door pulls of all GTs which use the small vinyl topped...

Fully reconditioned Benditalia / Bonaldi brake servo unit as fitted to all right hand drive 105 Series cars to 1978 and all left hand drive standing pedals cars. Please note that this part is sold on an exchange basis and the price includes a...

Single banjo fuel union to suit Weber DCOE 40/45/48 carbs.

GT map pocket pair. Will fit later GTs without a flat dash. Made in hard plastic.

Athena head gasket for 2 litre Twin-Spark (75) engine.

Weber 32mm choke, suitable for 1750 & 2000 engines 

Weber 30mm choke, suitable for 1600 engines 

Weber 28mm choke, suitable for 1300 engines 

Weber main jet 135, suitable for 2000 engines 

Weber main jet 130, suitable for 1750 engines 

Weber main jet 125, suitable for 1600 engines 

Weber main jet 112, suitable for 1300 engines 

GT map pocket pair. Will fit early GTs with a flat dash. Made in hard plastic. This set comes with 4 pop rivets for mounting.

GT map pocket right side. Will fit all GTs. Made in hard plastic.