Categories

Nut for layshaft on 116 and 75 models.

Nut for mainshaft on 116 and 75 models.

Oil seal for shift shaft on 116 and 75 models.

Detent ball bearing for gearshift in 101, 105, 116 and 75 models.

Transaxle oil seal for all 116 and 75.

Pinion ring bearing for GTV6 and 75. 85x45x19mm: please check the size of your old bearing before ordering.

Mainshaft centre bearing for series 1 Alfetta and GTV.

Pinion ring bearing for 116 and 75. 80x40x19mm: please check the size of your old bearing before ordering.

Mainshaft rear bearing for 116 and 75.

Bellhousing inner bearing for 116 and 75. Please check size before ordering (62 x 35 x 14mm).

Air intake hose for some 75 TS models.

Air intake hose for some 4 cylinder 75 models.

Air intake hose for GTV6 and V6 75 models. Made in long lasting silicone.

Air intake hose for GTV6 and V6 75 models.

Air filter for all V6 116 and 75 models.

Plastic support bracket for some 4 cylinder 116 and 75 models.

Air filter for some 116 models. 15cm diameter by 37cm length. Please check measurements before ordering.

Air filter for some 116 models. 15cm diameter by 34cm length. Please check measurements before ordering.

Blanking plate for use where you are using a GTA oil cap and therefore do not need the standard breather elbow.

Gasket for the joint between the cam cover and breather elbow on 105 and some 116 models.

Clutch kit (new) for 4 cylinder 116 and 75 models with 215mm disc. Please check clutch disc diameter before ordering.

Clutch kit (new) for V6 models with single disc. This clutch kit replaces the 190mm twin disc, with a single 215mm disc. Will fit the following vehicles; 116: 2.5 V6 & 3.0 V6 75: 1.8 Turbo, 2.5 V6, 3.0 V6 RZ & SZ: 1988-1994 3.0 V6

Clutch release bearing (Sachs) for 4 cylinder Alfetta and 75 models.

Clutch master cylinder with reservoir for most 116 and 75 models.