Categories

Valve spring retainer to fit performance valves with 8mm stem diameters. Sold individually.

Inlet valve guide to match the performance valve with 8mm diameter valve stem available under item code EN589.

Valve guide to fit FIA specification GTA inlet valves with 8mm stem diameter. Please note that original GTA valves were 8.5mm stem, we use an 8mm valve as it will improve intake flow.

Valve guide to fit FIA specification GTA exhaust valves with 8mm stem diameter. Please note that original GTA valves were 8.5mm stem, we use an 8mm valve as it will improve exhaust gas flow.

Valve guide to fit performance valves with 9/32" diameter valve stems. Can be used on both inlet and exhaust valves.

Rubber/metal/plastic steering column joint to suit right hand drive 2600 cars.

Rubber section that seals around the edge of the radiator aperture in the bodywork on all 105 series GT & GTV, Spider and Saloons from about 1967 onwards where the radiator sits on a rubber support (available under item code WA050) on the front...

Engine oil pump to suit both 1300 and 1600cc 101 series engines. Does not include the pickup pipe.

Magneti Marelli style distributor cap and ignition rotor kit to suit 8 plug GTA distributor with 10mm shaft, usually found on 1300 GTAs and some 1600 cars.

Brake master cylinder seal kit to suit 3/4" (19mm) master cylinders as fitted to 101 Series cars with front disc brakes.

105.26 body type plate to suit left hand drive 1600 Giulia Super saloons made from 1965-1972

The classic Zagato 'Z' badge as found on Zagato bodied cars for many years, including the Junior Z, Giulietta SZ and Zagato bodied 1900 models as well.

Two piece Junior Z rear script badge to go on the rear of 1300 Junior Zagato coupes.

Lower door skin repair section to suit all Giulia saloon doors - rear right.

Lower door skin repair section to suit all Giulia saloons - rear left

Pair of carburettor rubber mounts to suit the triple Solex carburettors fitted to 2600 engines (3 pairs required) or twin Solex 2000 engines (2 pairs required). Please note the reason these are sold as a pair is because each carburettor mount has a...

Headlining kit to suit all Giulia Sprint GTAs. Made in Italy in the correct pattern and 'snakebite' material by the leading classic Alfa Romeo upholstery specialists. Note - this is a different style to the regular GT /GTV headlining and does...

Pair of rubber seals (left and right) for the rear light units on Kammtail Spiders 1970-84

White/clear rear lens for the reversing light in a 1970-83 Kammtail Spider. Right hand side as viewed from the rear of the car.

Original Sachs clutch release bearing to fit all hydraulic clutch 105/115 series cars including Montreals.

Plastic wheel centre badge to suit the 15 inch wheels originally fitted to Series 4 Spiders. 50.5MM diameter with plastic clips on the rear to slot into the wheel centres.

Green cloverleaf triangle sticker - 9cm length base

Right, GTA green cloverleaf triangle sticker - 15cm length base. Note these large stickers are 'handed' with stalks on different sides of the cloverleaf and correct for 1300 and 1600 GTA.

Remanufacturered tube nut for the tail light unit on Kammtail Spiders. Each tail light has 4 tube nuts per side.