Categories

Spring for clutch arm / fork. Retains the arm in the bell housing.

Top timing chain to fit all 1600cc 101, 105, 116 and 75 engines.

105.04/A engine bay type plate to suit right hand drive 1600 GTA cars.

Rear stainless steel exhaust pipe section without a silencer/muffler - for better longevity and a more sporting exhaust note! LHD & RHD: Fits all GTs/GTVs and Giulia saloons up to 1978. Please see EX023 for the corresponding exhaust O-ring

105.21 body type plate for the left hand drive version of the Giulia 2000 GTV LHD, 1971-1976.

Fixing tab rampipe 40 DCOE. 4 required per carburettor. 

Fixing tab rampipe 45 DCOE. 4 required per carburettor. 

Side air vent hose for all 105 Spiders with 1300/1600 engines from 1966 to 1978 (goes to the back of the round vents).  Two per car.

Differential pinion inner (Rear) bearing to fit all 750 series cars as well as some early 101 series cars. High quality bearing. If you have a 101 Series car please measure your bearings and compare between this bearing and GB050/1...

Differential pinion outer (front) bearing to fit all 750 series cars as well as some early 101 series cars. High quality bearing. If you have a 101 Series car please measure your bearings and compare between this bearing and GB050. Dimensions: Outer...

115.01 body type plate for the left hand drive version of the 2000 GTV USA spec, 1971-1976.

105.36 body type plate for the left hand drive version of the Giulia Sprint GT Veloce LHD, 1965-1968.

105.25 body type plate for the left hand drive version of the Giulia GTC LHD, 1964-1966.

105.44 body type plate for the left hand drive version of the Giulia GTV 1750 LHD,1967-1972.

105.30 type plate for the left hand drive version of the Giulia Sprint GT Junior, 1966-1971.

105.02 body type plate for the left hand drive version of the Giulia Sprint GT, IGM 3235. 1963-1966

105.36 body type plate for the left hand drive version of the Giulia Sprint Veloce, 1965-1968.

105.59 body type plate for the left hand drive version of the Giulia Sprint Junior 1300 GTA, 1968-1972.

Side air vent hose for late GT Junior / 2000GTV dashboard (goes to the back of the "eyeball" vents). Two per car.

Pertronix high performance ignition coil. Black body, 1.5 ohm, around 40,000 volt output. Suitable for full race engines - Ideal for use with the Pertronix Electronic Ignition kits available separately. Standard engine will overheat with this coil...

Set of 4 Pipercross ram pipes to fit 45mm carburettors. 

Rubber dash vent hose (11 cm long) that fits between the heater and the centre dash top vents on all 105 Series GTs/GTVs with the later style heater used from about 1968 onwards. Two used per car.

Oil sandwich plate kit to suit post '72 'spin-on' style oil filters. Includes sandwich plate and stainless steel braided hoses. Use in conjunction with one of the 13 row oil coolers available under item code EN570 (115mm) or EN571 (235mm).  See item...

Pair of 70mm mesh filters to fit over the Weber 48mm DCOE rampipes. Two pairs required per car.