EX023 EXHAUST TAILPIPE O RING

A useful kit containing all the items you would normally need to fit a standard exhaust onto a 105 Series car. See also EX036 for the metal plates and inserts for the rubber hangers.

Bush for the gearbox/exhaust hanger bracket that bolts to the gearbox or transaxle on 105, 116 and 75 models. 2 required per car on 105 models and 1 per car on 116 and 75 models.

Copper cylinder head to exhaust manifold gasket to suit all 101 and 105 series engines plus 4 cylinder 116 models and 4 cylinder 75 engines (not TS).

Exhaust/inlet manifold stud 34mm to suit all 4 cylinder 101, 105, 116 and 75 engines, including TS. There are 8 on the exhaust side and 7 on the inlet side, of which three are longer and not...

Set of 2 metal plates and the insert for the bolt hole on the rubber exhaust hanger on all 105/115 series cars. Two sets are required for each hanger, usually 4 per car (2 rubber hangers). Also...

Middle exhaust heat insulation/protection plate that attaches to the floor above the main central muffler/silencer on all 105 series cars. See item code EX026 for the smaller plate that goes at the...

Exhaust manifold nut to suit 101, 105, 116 and 75 engines, including V6. 8 fitted per cylinder head. These are a smaller outer diameter than the original which makes tightening easier as you have...

Exhaust clamp to suit all standard sized (54mm) 750, 101 and 105 series exhaust systems. Usually one clamp per car, located on the join between the front and middle exhaust sections.

Rear exhaust pipe section to suit Series 3 and Series 4 Spiders from 1983-93. This version is without a silencer for a more sporting exhaust note! Made in Italy by IMASAF - OE Quality...

Timing cover "O" ring. Please see pictures for fitting location.