The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.
Gearbox rear mounting bush 2nd series - for all hydraulic clutch gearboxes - 1968-1993.
Gearbox rear mounting bush (64mm diameter) to suit cable clutch 105 series cars up to 1967. Also fits 101 Series cars as well as 102 & 106 series 2000 & 2600 models - both in the...
Gearbox rear mounting bush (48mm diameter) to fit 750 and early 101 four speed gearbox.
Gearbox rear mounting bush bolt. Will fit all 105 cars.
Standard bush for the rear joint that connects to the rear axle on the rear suspension trailing arm for all 105/115 series cars. Approx 44mm diameter. See item code SU062 for an uprated version...
Bush for the gearbox/exhaust hanger bracket that bolts to the gearbox on all 105 series cars and is usually affected by heat and oil! Two required per car.
Protective large rubber washer/spacer for the rear gearbox mount on all 105 series cars. Sits either side of the rear metalastic mount inside the gearbox crossmember. 2 washers required per car.
Here is a diagram showing the location of some of the parts in this category.
Engine mount and metal frame for the left (exhaust) side of the engine.
'Doughnut' style rubber transmission front coupling to fit all 750, 101, 102, 105 and 106 series cars except Montreals.
Engine mount and metal frame for the right (intake) side of the engine.
Propshaft centre support bush and bracket to suit Hydraulic clutch models 1968 onwards. Holds the centre support bearing available separately under code GB030, which is retained by a circlip...
OE quality Corteco brand front gearbox to bell housing oil seal to fit all 105 Series cars with hydraulic clutches.
Reproduction rubber combination gearbox gaiter to suit 105 series cars from late 1960s onwards. Two part gaiter, with the inner section that attaches to the 'tower' at the rear of the...