The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.
Large rubber seal/gasket that fits between the transmission tunnel pressing and the transmission tunnel apeture cover (either metal or plastic/foam versions) on most of the 105 series range. Fitted to Sprint GT, GTV, GTC & GTA models, all Roundtail and Kammtail Spiders to 1982 and all Saloons. Also possibly fitted to later Spiders and GTVs, but it is unclear from both the parts books and practical experience as there does not seem to be a consistent fitment. May also be used on some 750 and 101 series cars as well.
Rubber gaiter that fits over the transmission tunnel aperture cover (that attaches to the transmission tunnel pressing) inside the cockpit of all 105 series Coupes, Saloons and Spiders...
Excellent quality reproduction transmission tunnel vinyl mat set to suit all GT Juniors 1966 to 1973. Will also fit other GTs/GTVs if you are removing the centre console(s) for competition purposes...
Set of pedal aperture finishing rubbers for carpet set. If you are having a carpet set made for your standing pedals Bertone GT these are essential to get the original look prevent wear ...
Rubber gaiter that fits over the transmission tunnel aperture cover (that attaches to the transmission tunnel pressing) inside the cockpit of all 105 series Coupes, Saloons and Spiders. Is covered by...
Reproduction rubber combination gearbox gaiter to suit 105 series cars from late 1960s onwards. Two part gaiter, with the inner section that attaches to the 'tower' at the rear of the gearbox and the...
Gearbox inner rubber gaiter. Fits over the rear 'tower' of the gearbox where the gear lever attaches to the gearbox on 101 and 105 Series 5 speed gearboxes. Fitted to all mechanical clutch cars and...
Small rubber gearbox seal. sits under the gear lever and on top of the metal plates on the rear 'tower' of the gearbox. Use in conjunction with the small washer available under code GB039/1.
Rubber gaiter that fits over the clutch actuating arm where it enters the gearbox bell housing on all mechanical clutch cars. Note, this only fits mechanical clutch cars. Hydraulic cars do not use a...
Small rubber grommet for the holes that the under bonnet/hood wiring passes through on many of the 105 series cars. Also fits the rear valance panel where wiring for the rear numberplate lights...
Excellent quality reproduction transmission tunnel vinyl mat set to suit all GT Juniors 1966 to 1973. Will also fit other GTs/GTVs if you are removing the centre console(s) for competition purposes.
Rubber section that seals around the edge of the radiator aperture in the bodywork on all 105 series GT & GTV, Spider and Saloons from about 1967 onwards where the radiator sits on a rubber support...