Categories

OE quality valve guide stem seal -  to fit the inlet valve guide on all 101, 105, 116 and 75 engines (including V6) with 9mm valves and valve guide stem seals. Goetze brand or similar. Also used on the inlet guide on Montreal engines. Not suitable for TS.

Cam/Valve cover nut to suit early 750 Veloce Series & Sprint Speciale engines.    6 required per car.

Outer stainless sill trim. All Spiders from 1966-93. 

Inner stainless sill trim. All Spiders from 1970-93.  Please note, on Series 4 cars this part was powder coated in black, even though it is exactly the same in appearance  

Outer chrome moulding. Sits on the top of the door horizontally against the glass. All Spiders from 1970-93. Right hand side.

Outer chrome moulding. Sits on the top of the door horizontally against the glass. All Spiders from 1970-93. Left hand side.

Drive belt to fit fuel pump on all 4 cylinder SPICA fuel injected cars 

Small oil filter (35mm diameter) to fit the Spica mechanical fuel injection pump on all 4 cylinder USA specification cars.

Pair of air filters to fit the intake system of US specification SPICA mechanical fuel injection 4 cylinder cars. Dimensions: Length - 185mm Diameter - 90mm

Cam/Valve cover nut to suit 750 Series, 1900s and 102 Series 2000 engines. 6 required per car.

Seal kit to suit Dunlop front brake caliper as fitted to earlier 105 Series cars. Each kit contains seals for one brake caliper.

GT panel for base rear screen

Enamel cloverleaf self adhesive (50mm)

Comprehensive set of rubber seals for all Kammtail Spiders, consisting of: RB011 - Door glass felt x2 RB021 - Windscreen rubber RB024 - Main door seal x2 RB023 - Main door seal end plug x4 RB025 - Left quarterlight seal RB026 -...

Set of fuel MULTIPOINT injectors for Bosch Motronic 89-93. These injectors Replace Yellow Bosch 0280150962

Clutch release bearing to suit 1900/102 series cars. This is the bearing only (not the carrier). Please check the dimensions of your current bearing against the dimensions below as there were some variations on release bearings used over the years...

Fuel tank filter rubber gasket to suit all Montreals. Original Part Number: 105.64.32.229.00

Cloverleaf self adhesive badge (35mm)

Cloverleaf self adhesive badge (53mm)

Valve shim to fit GTA, 750 Giulietta and 75 Twin Spark engines. They are available in increments of .025mm from 1.500 (.059")  to 3.500 mm (.138"). Please select size from the drop-down menu.       

Stainless steel inner headlight ring to fit non-stepfront GTVs and GT Juniors. 

New fuel tank sender to fit 2000 Berlina with VEGLIA instruments. Cars with 55 litre fuel tanks and tube measuring between 230-240mm If you have a GTV or Spider with Veglia instruments (not that we have ever seen this!) this will also be the correct...

Rebuild kit for front DUNLOP brake calipers, including new pistons and seals. One kit rebuilds 2 x calipers.     

Front spring pan bolt to wishbone. If you require the nut please see SU147.