40mm paper carburettor mount gasket to fit all 40mm Weber, Solex and Dellorto carburettor mounts. 2 required per rubber mount/carburettor throat.
The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.
Carburettor rubber mount to suit 40mm Weber, Dellorto and Solex carburettors. Used on all 105 series GT/GTV, Saloons and Spiders as well as 101 Series Veloce cars. Normally 4 required per car, but...
Set of 4 individual solid aluminium carburettor mounts to fit 40mm carburettors but anodised in black to retain an original appearance to your engine bay. Machined from solid aluminium then...
40mm Carburettor rubber mount used on Series 4 1600 Spiders and found on some late S3 Spiders. If you require the centre double support please see FL097 Paper gaskets are available under code FL021...
40mm Carburettor twin rubber centre mount used on Series 4, 1600 Spiders and found on some late S3 Spiders. If you require the outer single support please see FL096 Paper gaskets are available under...
Inlet carburettor gasket found on Series 4 1600 Spiders and also some late S3 Spiders. Four required per car, you will also need four FL021. If you require the carburettor supports please see FL096...
Carburettor rubber mount to suit 40mm Weber, Dellorto and Solex carburettors. Used on all 105 series GT/GTV, Saloons and Spiders as well as 101 Series Veloce cars. Normally 4 required per car, but...
Siamesed carburettor rubber centre mount and two individual to suit 40mm carburettors. This mount replaces the two separate central mounts and bridges between the two carburettors. These must...
Set of 4 individual solid aluminium carburettor mounts to fit 40mm carburettors but anodised in black to retain an original appearance to your engine bay. Machined from solid aluminium then...
Inlet manifold gasket to fit all twin carburettor 105 series cars and Spica equipped models. For early single carburettor cars see code FL022/1 and for later Fuel Injected cars see FL039.
Gasket to fit between the air intake trough/plenum and the carburettor body on all carburettored 105 series cars fitted with side draught carburettors.
Inlet manifold gasket to fit all early carburettor 101 and 105 series cars. For later carburettor cars see code FL022 and for later Fuel Injected cars see FL039.
45mm paper carburettor gasket,
Earth strap to fit the carburettor mounts on all 105 Series carburettor cars. Often missing or damaged on many cars we see, ideal to replace when you fit new carburettor mounts.
Set of 4 individual solid alloy carburettor mounts to fit 45mm carburettors. Set includes 'O' rings , thackery washers and nylock nuts for the carb side plus plain nuts for the inlet manifold side...
Carburettor rebuild kit to suit Weber 40 DCOEs - kit does 2 carburettors