The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.
Rubber gaiter that fits over the transmission tunnel aperture cover (that attaches to the transmission tunnel pressing) inside the cockpit of all 105 series Coupes, Saloons and Spiders. Is covered by the centre console in cars with the consoles fitted and by a vinyl gear lever gaiter in cars without a centre console. Also fits some later 101 Series cars and well as some 102 (2000) and 106 Series (2600) cars. Base diameter approximately 120mm (12 cm) Can also be fitted to Montreals with some careful warming and stretching! Note also availabe is the large rubber gasket/seal to fit under the transmission tunnel apeture cover on many cars - see code GB048
Reproduction rubber combination gearbox gaiter to suit 105 series cars from late 1960s onwards. Two part gaiter, with the inner section that attaches to the 'tower' at the rear of the...
Gearbox inner rubber gaiter. Fits over the rear 'tower' of the gearbox where the gear lever attaches to the gearbox on 101 and 105 Series 5 speed gearboxes. Fitted to all mechanical...
Rubber gaiter that fits over the clutch actuating arm where it enters the gearbox bell housing on all mechanical clutch cars. Note, this only fits mechanical clutch cars. Hydraulic cars do...
Protective large rubber washer/spacer for the rear gearbox mount on all 105 series cars. Sits either side of the rear metalastic mount inside the gearbox crossmember. 2 washers required per car.
Reproduction rubber combination gearbox gaiter to suit 105 series cars from late 1960s onwards. Two part gaiter, with the inner section that attaches to the 'tower' at the rear of the gearbox and the...
Large rubber seal/gasket that fits between the transmission tunnel pressing and the transmission tunnel apeture cover (either metal or plastic/foam versions) on most of the 105 series range. Fitted...
Gearbox inner rubber gaiter. Fits over the rear 'tower' of the gearbox where the gear lever attaches to the gearbox on 101 and 105 Series 5 speed gearboxes. Fitted to all mechanical clutch cars and...
Small rubber gearbox seal. sits under the gear lever and on top of the metal plates on the rear 'tower' of the gearbox. Use in conjunction with the small washer available under code GB039/1.
Gear gaiter base, GTV & late Juniors with centre console. Please note, you will need to drill the fixing holes on the cover. We understand that the early MK1 1750 was not fitted with this surround.
Rubber gaiter that fits over the clutch actuating arm where it enters the gearbox bell housing on all mechanical clutch cars. Note, this only fits mechanical clutch cars. Hydraulic cars do not use a...
Large rubber floor bung to fit into the pressing holes in the floor panel of all 105 Series cars. Also used in the spare wheel well too. Total 8 required for GTs, Saloons and Montreals and 6 required...
Quality Italian leather gear lever gaiter - 4 rows of stitching for cars with centre console (1750/2000GTV, Spider S2, S3, late GTJunior Berlina).
This gaiter is for the Alfa owner that wants...