The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.
Accelerator pedal to fit all 105 Series cars plus 750,101, 102 and 106 series models. NOT SUITABLE FOR S4 SPIDER
Clutch pedal pivot shaft for left hand drive cars 105/115 & Montreal series cars with hanging/top hinged pedals.
Clutch master cylinder repair kit to fit all left hand drive cars with hanging pedals, including some Montreals. Please check your old cylinder before ordering - if your master cylinder has 3 seals...
Rubber seal to fit between the pedal housing and the bodywork on all left hand drive 105/115 Series cars with hanging pedals.
Clutch master cylinder to fit all left hand drive 105 Series cars with hanging pedals 1970-93, including Montreals. Reservoir available separately - see code CL002 if you require the...
Pedal box frame left hand drive standing pedal cars
Series 2 Kammtail Spider 1970-84 rubber floor mats with Alfa logo, for LHD cars with hanging pedals, sold as a pair. Excellent quality and reproduced in the correct style.
Brake light switch to suit left hand drive cars with hanging pedals up to the end of the Series 3 Spider range. Also fits all Alfetta models.
Bracket gearbox - exhaust. For 105 series cars with hanging pedals. Length 32cm
Quality Italian leather gear lever gaiter - 5 rows of stitching with stitched finish at the base for cars without centre console, black. This gaiter is for the Alfa owner that wants to treat...
Beautifully made grey pair of inner door panels to suit all Sprint GTs and GTVs as well as GT Juniors and 1750 GTV Mk 1 models. Done in the correct style and material.
Carpet set to suit all left hand drive Bertone 1750 GTV mk1 from 1967-69. Produced in the correct orginal style and grey colour . See also item code IN311 for right hand drive Mk 1 1750 GTVs with...
Armrest support plate. Suitable for GT 1300, 1600 & 1750 (with plastic door handles) & Giulia saloon 1300, 1600. Will do both right and left door. Please note early GTs with foam door...
Mechanical fuel pump for 105 and 116 series carb engines with outlets to the top and side.
12V ignition coil for 750, 101 and 105 series cars and 4 cylinder carb-equipped 116 and 75 models. NGK products are known for reliability!
FISPA decal to fit on the top of the air box, normally used on 105 series cars, using air filter EN051.
Retaining clip required to fit the clutch release bearing available under item code CL041 (rounded ends). Two required per car.
Set of gear gaitor trim clips. Used to hold the gear lever vinyl gaiter in place.
Gear gaiter base, GTV & late Juniors with centre console. Please note, you will need to drill the fixing holes on the cover. We understand that the early MK1 1750 was not fitted with this...