116 ALFETTA PARTS : FUEL

We are taking delivery of 116 and Alfetta parts every week and will be adding them to our website as soon as they are unboxed and photographed.

Fuel pump relay to suit all Alfetta GTV6's and 75 V6's. This relay has been encased in a custom 3D printed plastic shell, with the original BOSCH part number inscribed on the top (0.332.514.121)

Fuel tank sender to suit Alfetta Saloons, as well as 4 cylinder Alfetta GTV's. Not suitable for GTV6

Accelerator cable GTV6 LHD. 

Malpassi Fuel filter set 42mm GTV 116

Fuel filler neck seal for some 116 models. Please check photos before ordering.

Fuel pressure regulator for S4 spiders and fuel injected, 4-cylinder 116 and 75 models.

Bush for the stay arm that supports the plenum on S4 spiders plus fuel injected 4 cylinder 116 and 75 models.

O-ring that seals the injector into the inlet manifold on fuel injected 105 (115), 116 and 75 engines, including GTV6 and 75 V6.

Mechanical fuel pump for 105 and 116 series carb engines with outlets to the top and side.

Mechanical fuel pump for 105 and 116 series carb engines with inlet and outlet pointing to the side.

Short air intake hose for GTV6 and 75 V6.

Air intake hose for GTV6 and V6 75 models. Made in long lasting silicone.

Air intake hose for GTV6 and V6 75 models.

Air filter for all V6 116 and 75 models.

Plastic support bracket for some 4 cylinder 116 and 75 models.

Air filter for some 116 models. 15cm diameter by 37cm length. Please check measurements before ordering.

Air filter for some 116 models. 15cm diameter by 34cm length. Please check measurements before ordering.

Blanking plate for use where you are using a GTA oil cap and therefore do not need the standard breather elbow.

Gasket for the joint between the cam cover and breather elbow on 105 and some 116 models.

Mechanical fuel pump to fit all carburettor-equipped 105 series cars plus 101 series 1300 and 1600 Normale cars. Also fits some Alfetta models. Mounting gaskets and plastic spacer blocks are available separately.   This is a new production and the best...

Thackery washer, carburettor mounting. 5/16 - M8 fitting. 

Gasket for the fuel pump mounted on the lower front timing cover on carburettored 101 Normale and 105 Series cars plus 116 and 75 models with carbs.. There should be two gaskets fitted - one either side of the plastic insulating spacer block (available...

Aluminium blanking plate to seal off the mechanical fuel pump mounting on carb equipped 101, 105, 116 and 75 models. This is used when fitting an electric fuel pump to the car.