Categories

Reduction gear lightweight starter motor - far more powerful than standard Alfa unit, less weight and uses much less power. For all Type 106 - 2600 cars 1961-1968

Windscreen pillar base  seals, pair,  2600 Spider & 2000 (102) Touring.  

Lock Tab washer for splined hub 1900. Only for cars with splined front hubs for wire wheels..

Plastic throttle rod end, as per the original type on all Montreals.

Lucas voltage regulator. Fits early 750 cars and some 1900 cars.

New production of the black plastic steering wheel centres found on the 'shallow dished' 3 spoke bakelite steering wheels used in Giulia Sprint GT Veloce and 1600 Roundtail Spider 1966-67 only. This has a different, flatter profile on the sides to the...

Front hub oil seal 72 x 48mm

Carello branded left front sidelight lens to fit all Roundtail Spiders 1966-70. Clear lenses as used on German and US specification cars.

Nut for attaching the clutch flexi hose to the bracket on the rear of the crossmember on all hydraulic clutch 105 Series cars.  

New production of the plastic steering wheel centre cap to fit the deep dished Personal brand steering wheel (and also some Hellebore sterring wheels) with square cap attachement holes, fitted to cars from about 1972 onwards. For Hellebore brand deep...

New production of the plastic steering wheel centre cap to fit the deep dished Hellebore steering wheel fitted to cars from about 1972 onwards with round cap attachement holes. For Personal brand deep dished steering wheels and Hellebore wheels with...

New production of the black plastic steering wheel centres usually found on the 'shallow dished' Hellebore steering wheels used in 1750 GTVs, Spiders and Berlinas, as well as some other models. These are polished to perfection and the finish is better...

Right side fixing/stiffener panel to fit Series 4 Spider hoodbags. Please note, the mounting brackets and rivets are included separately and will need to be fixed in place before fitting.

Left side fixing/stiffener panel to fit Series 4 Spider hoodbags. Please note, the mounting brackets and rivets are included separately and will need to be fixed into place before fitting.

Upper front suspension wishbone bush for 750 Series cars. 2 per side, 4 in total per car. Approximate internal diameter 13.9mm. See 101-051 for the larger bush for 101 Series cars.

Lower wishbone bush to suit 750 Series cars. 2 per side, 4 in total per car. ID - 15.5mm (approximately) See 101-050 for the larger bush for 101 Series cars.

Aluminium propshaft centre bearing mount to suit 750, 101, 102 (2000) and 106 (2600) Series cars.

Drop-in style thermostat to suit all 101 series vehicles.

Stud for the rear of the engine block to attach the bell housing of the gearbox on all hydraulic clutch 105 twin-cam engines. 4 studs used in total. For the relevant nut, see part FL109.

Metal air hose clamp to suit 750, 101, early 105, 102, 106 series cars. Can be bent to suit various sizes / applications.

Viton fuel resistant rubber O ring to suit all solid carburettor mounts - as we have available under item codes FL017 and FL018. Ideal if you lose or damage an O-ring when fitting.

Carpet set for the main cabin area of a Series 4 Spider in black. Made in individual, tailored pieces to replace the original one piece moulded carpet which is no longer available. Made for left hand drive cars with the heel...

Carpet set for the main cabin area of a Series 4 Spider in tan. Made in individual, tailored pieces to replace the original one piece moulded carpet which is no longer available.  Made for left hand drive cars with the heel mat on the left side, but will...

Lucas rotor arm to suit 750 Series cars.