Stud for the rear of the engine block to attach the bell housing of the gearbox on all hydraulic clutch 105 twin-cam engines. 4 studs used in total.
For the relevant nut, see part FL109.
The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.
Standard clutch spigot bush (24mm) to suit hydraulic clutch 105 series twin cam engines. Also fits Montreal engines Please note some early 1750 engines uses te earlier bush - sold under code...
Gearbox mainshaft rear bearing to suit hydraulic clutch gearboxes. Inside diameter 25mm, outside diameter 52mm, width 15mm.
Propshaft centre support bush and bracket to suit Hydraulic clutch models 1968 onwards. Holds the centre support bearing available separately under code GB030, which is retained by a circlip...
Rubber gaiter that fits over the clutch actuating arm where it enters the gearbox bell housing on all mechanical clutch cars. Note, this only fits mechanical clutch cars. Hydraulic cars do...
Clutch cover plate bell housing. Hydraulic clutch cars only.
Front crankshaft oil seal to suit all 4 cyl engines incuding TS. See also EN036/1 for a top quality Corteco version of this seal.
Spacer plate for bell housing. Please check photo carefully, to make sure this part is correct for your vehicle. This spacer is generally fitted on cars with hydraulic clutch from...
Athesil RTV silicone sealant. A premium sealant/ gasket maker developed by Athena for professional use in engine maintainace and repair. The RTV (room temperature vulcanizing) silicone seals plastic...
M8 x 1.0 nut. Fits the rubber carb mounts (FL014) used on most 105 series cars and the engine to bellhousing stud (EN135).
Headlight main beam warning lamp, fitted on many 105 cars. BLUE.
Handbrake warning lamp, fitted on many 105 cars. RED.
Tab washer to suit the retaining bolts on an 8 bolt flywheel as fitted to 1300, 1600 and 1750 engines (except for 1600 Spider S4 engines that use 6 bolt flywheels). 4 required per engine. We...
Right GT door glass guide, rear of door. Bertone GT.
Cylinder head nut washer. All 4 cylinder engines.
Window pulley for cable driven regulator. To fit all 105 & 115 Cars. 40mm O/D 10mm ID. Please note, GT are pressed fitted into place, the only way the pulley can be replaced, is when the...