Stud for the rear of the engine block to attach the bell housing of the gearbox on all hydraulic clutch 105 twin-cam engines. 4 studs used in total. For the relevant nut, see part FL109.
GB042 RUBBER GAITER - GEARBOX BELL HOUSING, ME…
Rubber gaiter that fits over the clutch actuating arm where it enters the gearbox bell housing on all mechanical clutch cars. Note, this only fits mechanical clutch cars. Hydraulic cars do...
$37.08
EN175 BELL HOUSING TO BLOCK SPACER PLATE
Spacer plate for bell housing. Please check photo carefully, to make sure this part is correct for your vehicle. This spacer is generally fitted on cars with hydraulic clutch from 1968-1975...
$56.56
GB103 GEARBOX BELLHOUSING 1300-2000 HYDRAULIC …
Gearbox bellhousing with non-exposed gear selector rods. Suitable for all 105 cars with hydraulic clutch.
$465.02
CL039 CLUTCH COVER PLATE BELL HOUSING
Clutch cover plate bell housing. Hydraulic clutch cars only.
$37.70
EN175/1 BELL HOUSING TO BLOCK SPACER PLATE
Spacer plate for bell housing. Please check photo carefully, to make sure this part is correct for your vehicle. This spacer is generally fitted on later cars from 1983 onwards. If...
$25.14
GB102 GEARBOX BELLHOUSING 1300-2000 HYDRAULIC …
Gearbox bellhousing with exposed gear selector rods. Suitable for all 105 cars with hydraulic clutch.
$439.88
GB028 PROPSHAFT CENTRE SUPPORT - HYDRAULIC CL…
Propshaft centre support bush and bracket to suit Hydraulic clutch models 1968 onwards. Holds the centre support bearing available separately under code GB030, which is retained by a circlip...
$25.14
EN040 CRANK SPIGOT BUSH - HYDRAULIC CLUTCH CAR…
Standard clutch spigot bush (24mm) to suit hydraulic clutch 105 series twin cam engines. Also fits Montreal engines. Some early 1750 engines uses the earlier bush - sold under code EN101...
$8.17
GB015 MAINSHAFT REAR BEARING - HYDRAULIC CLUTC…
Gearbox mainshaft rear bearing to suit hydraulic clutch gearboxes. Inside diameter 25mm, outside diameter 52mm, width 15mm.
$45.24