GB012 MAINSHAFT FRONT BEARING - MECHANICAL CLUTCH GEARBOXES

Mainshaft front bearing to suit hydraulic clutch gearboxes. Inside diameter 30mm, outside diameter 62mm, width 23.8mm.

Front gearbox to bell housing oil seal to suit mechanical clutch 750/101/102/105 cars and all 2600 (which are hydraulic clutch). NOT suitable for early "split case" 750 gearbox.

Gearbox mainshaft rear bearing to suit hydraulic clutch gearboxes. Inside diameter 25mm, outside diameter 52mm, width 15mm.

Mechanical/cable clutch release bearing to suit clutches on 750, 101 and early 105 series cars. Please check photos for measurements.

Tab washer to fit on the rear of the gearbox mainshaft on all 101 Series 5 speed gearboxes and 105 Series 5 speed boxes up to appoximately 1972. Due to gearbox interchangeability, you may find this...

Rubber gaiter that fits over the clutch actuating arm where it enters the gearbox bell housing on all mechanical clutch cars. Note, this only fits mechanical clutch cars. Hydraulic cars do...

Mainshaft rear bearing to suit mechanical clutch 105 series cars. Also fits 102, 106, 750 and 101-series cars but check sizes. Inside diameter 25mm, outside diameter 52mm, width 15mm.

Rear layshaft bearing (inside diameter 30mm, outside 62mm, width 16mm) to suit hydraulic clutch gearboxes.

Layshaft rear bearing to suit mechanical clutch 105 series cars. Also fits 5 speed 101 series, late 102 series and all 2600 (106 series). Outer diameter - 62mm Inner diameter - 30mm Thickness -...