EN175 BELL HOUSING TO BLOCK SPACER PLATE

Spacer plate for bell housing. Please check photo carefully, to make sure this part is correct for your vehicle. This spacer is generally fitted on later cars from 1983 onwards. If...

Clutch cover plate bell housing. Hydraulic clutch cars only.

Stud for the rear of the engine block to attach the bell housing of the gearbox on all hydraulic clutch 105 twin-cam engines. 4 studs used in total. For the relevant nut, see part FL109.

Rubber bung for gearbox bell housing. We understand this is only fitted to some 750 cars.

Pedal box spacer plate, all 750 and 101 cars. Stainless steel, includes fitting bolts. The master cylinder is hardly in an ideal position right next to the exhaust down-pipes or manifold,...

Rubber gaiter that fits over the clutch actuating arm where it enters the gearbox bell housing on all mechanical clutch cars. Note, this only fits mechanical clutch cars. Hydraulic cars do...

Gasket to fit the engine block rear cover plate on 750, 101, 105, 116 and 75 engines (excluding TS and V6).

Front gearbox to bell housing oil seal, to use a late hyradlic gearbox with an early cable clutch bell housing.