M8 X 1.25 NUT. Used on solid carb mounts (FL081) to attach to the inlet manifold.
The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.
13mm nylock nut to suit the propshaft bolt, available under code GB033. 8 required in total per car - 4 each end of the propshaft.
Input shaft front nut that retains the front gearbox bearing on later 'hydraulic clutch' gearboxes, generally, but not exclusively, found on cars from 1972 onwards.
Fits our battery clamp set and also the air filter housing of 105 series cars with the long air filter on the carb side.
M8 x 1.0 nut. Fits the rubber carb mounts (FL014) used on most 105 series cars and the engine to bellhousing stud (EN135).
Large wing nut that holds the jack in place.
M8 x 1.0 nut. Fits the rubber carb mounts (FL014) used on most 105 series cars and the engine to bellhousing stud (EN135).
Earth strap to fit the carburettor mounts on all 105 Series carburettor cars. Often missing or damaged on many cars we see, ideal to replace when you fit new carburettor mounts.
Carburettor rebuild kit to suit Weber 40 DCOEs - kit does 2 carburettors
Used inlet manifold for screw in thermostat 105 cars, this manifold is in very good condition, it does have some surface corrosion marks on it that could easily be cleaned up, the threads on all of...
A cheaper alternative to the original BOSCH fuel pump that we sell under FL028. External fuel pump to suit Bosch fuel injected Spiders, GTV6 and 75. Note that there is also a lift pump...
Giulia 105 two piece "GIULIA 1300 TI" script badge. Normally fitted on boot/trunk lid on early Giulia saloon. SIZE: GIULIA 1300 = 160mm wide, 20mm tall ...
An original cam cover for 101 series engine and GTAs that has been professionally cleaned and finished in crackle black. There is a £50 surcharge included in the price of this item that we...
A used crossover style air intake plenum, trough and air filter housing. These parts are sold as seen in the photos, they do have some areas of surface corrosion.
Set of 4 original primed steel wheels for 105 series models with 14 inch wheels and centre spinners. Size 5.5 x 14. 9.1 KG each. To suit 2 liter 105 cars. This set has some small scuffs and they are...
Used GTA style wheel, 7x14 ET23, this is not a usual style that we stock, the wheel has some scuffs and chips around the rim and hub center, all of which can be seen in the photos. Sold as seen.