MONTREAL PARTS : BRAKES

Brake pad fitting kit for Brembo calipers fitted to GTV6 and 75 V6 models. Also fits Montreals front calipers.

New production - pair of rear brake calipers to fit all Montreals.

Vented front brake disc for Alfa Montreal. 

Vented rear brake disc for Alfa Montreal. 

New production - pair of front brake calipers to fit all Montreals. Also fits Ferrari 308 models as well! 

 Give Your brakes the highest possible guarantee with the NEW Brembo B-Quiet lubricant. B-Quiet is a new Brembo lubricant which provides long term high load capacity and reliability for your braking system.The brake lubricant should be applied where the...

  ATE brake cylinder paste is used for repair, assembly and conservation of hydraulic brake components, It is applied thinly and evenly to cylinder sleeves, pistons and seals. (Assembly of Brake calipers, Master cylinder etc). - ATE brake cylinder paste...

Set of Ferodo rear brake pads to fit all ATE braked 105 Series cars.

Set of Ferodo front brake pads to fit the larger ATE brake calipers used on 1750 & 2000 engined cars and Montreals. Also used on 1.6 Spider from 1985 onwards.

Set of front brake pads from high quality manufacturer TRW to suit 1750/2000 105 series models and Montreals. Believed to be a superior pad on cars where it has been difficult to eliminate pad squeal.

Front RIGHT brake flexi hose bracket. To fit all 105 Series cars & Montreals. NOT SUITABLE FOR DUNLOP BRAKES

Front LEFT brake flexi hose bracket. To fit all 105 Series cars & Montreals. NOT SUITABLE FOR DUNLOP BRAKES

Goodridge braided brake line set (complete car set – 3 pieces). These stainless steel brake flexi hoses will improve the pedal feel and are guaranteed for life. This version is approved by the German TUV authorities and therefore suitable for the...

Brake flexi hose for the rear of all 105 series cars including Montreals, as well as 750 and 101 Series cars. Goes from the body to the rear axle. ONE PER CAR! Will also fit the hydraulic clutch hose on 2600 (106) cars. These hoses are compatible...

Brake flexi hose to fit the front brake system (between brake lines and calipers/drums) on all 105 Series cars including Montreals, as well as 750, 101 and 106 (2600) Series cars. These hoses are compatible with 3/8 UNF unions under the code BR322

Short front copper brake pipe from the flexible line to the brake caliper on all Dunlop braked cars from 1964-66. 

Short front brake pipe from the flexible line to the brake caliper on ATE braked cars from 1968-93 with large front calipers (1750+2000 models) including Montreals. Please specify if you require copper or cupro-nickel pipe on your order.

Rubber grommet for the inner guard/wing where the hydraulic brake pipe passes through the metalwork. Two required per car - one on each side. Also fit Montreal bonnet emergency release cable and the grommets for the headlight vacuum pipe.

Reservoir cap to fit the left hand drive clutch master cylinder reservoir. This cap will also fit the brake fluid reservoir on right hand drive 105 Series cars 1968 onwards and left hand drive cars 1968-70 with hydraulic clutch and single...

Rubber plug brake master cylinder, 15mm diameter. Used to connect the reservoir to the master cylinder. 

Rubber plug brake master cylinder, 20mm diameter. Used to connect the reservoir to the master cylinder. 

Bleed screw cap. Will fit all bleed screws.  

Brake disc/drum retaining screw.

Large sized brake caliper bleed screw to fit 1750/2000 ATE front brake calipers.