MONTREAL PARTS : RUBBER

Montreal fuel tank neck top seal.

Fr o n t w i n d s c r e e n s e a l t o s u i t M o n t r e a l s .

Fr o n t quarter light (triangle window) seal - LEFT

Fr o n t quarter light (triangle window) seal - RIGHT

Correct profile Montreal door window channel felt. Sold by the metre, each door requires 2.50mtr.

Rear window hatch to body seal to suit Montreals. See item code MN021/1 for the inner rear window to frame seal.

Rubber seal to fit the rear window glass to the supporting frame. See item code MN021 for the matching seal for the frame to the bodywork.

A pair of rubber seals (left and right) to fit between the tail light unit and the bodywork on all Montreals.

Pair of top quality correct pattern door seals to fit all Montreals.

Side window rubber/scraper to fit all Montreal doors. Sold in 1.3m lenghts.

Rubber gaiter that fits over the transmission tunnel aperture cover (that attaches to the transmission tunnel pressing) inside the cockpit of all 105 series Coupes, Saloons and Spiders. Is covered by the centre console in cars with the...

Rubber grommet for the inner guard/wing where the hydraulic brake pipe passes through the metalwork. Two required per car - one on each side. Also fit Montreal bonnet emergency release cable and the grommets for the headlight vacuum pipe.

Circular rubber firewall grommet for the speedometer cable and some wiring on left hand drive Montreals.

Rubber grommet for the hole in the firewall where the scuttle drain hose goes through. Fits all 105 and 115 series cars.

Oval rubber grommet for where the main wiring loom passes from the cabin into the engine bay on all 105 series cars.

Two piece rubber rrommet for the accelerator/throttle lever through where is passes through the bulkhead on all left hand drive cars.

Grommet for the heater hose where it passes through the firewall. Fits all 105 series cars from 1968 onwards. Two are required for right hand drive cars, one for left hand drive cars that use a different combined grommet for one of the heater hose...

Rubber plug/bung to fit all 105 Series Spider doors. Goes into the leading edge of the door to cover an access hole for a bolt on the quarterlight window frame. One used per door. Also fits Montreal doors.

Large rubber floor bung to fit into the pressing holes in the floor panel of all 105 Series cars. Also used in the spare wheel well too. Total 8 required for GTs, Saloons and Montreals and 6 required for Spiders.

Rubber grommet that fits into the rear of the boot/trunk floor on all 105 Series GTs/GTVs, all Giulia Berlina saloons and Kammtail/Series 2 Spiders 1970-84. It it is used to protect the wiring for the bumper mounted rear numberplate lights where it...

Brake pedal rubber to suit all 105 Series cars. Soften it in warm water before attempting to fit -you will find it much easier that way!

Clutch pedal rubber to suit all 105 Series cars. Soften it in warm water first before fitting - you will find it much easier to fit that way!

Brake / clutch pedal rubber with logo to suit all 105 Series cars. Although not original, the logo is a nice touch and reminiscent of the earlier Giulietta cars which did have this. Soften it in warm water before attempting to fit - you will find it much...

Small profile rubber 'U' section seal used in a variety of locations on all 105 Series cars, plus some Giulietta models as well. Also used on S3 and S4 Spider, on the outer headlight ring. Price is per metre