MONTREAL PARTS : RUBBER

Montreal fuel tank neck top seal.

Montreal rubber gear lever gaiter, fits under the vinyl gaiter.

Windscreen washer bottle cap for all Montreals. Used in conjuction with MN137

Windscreen washer bottle for all LHD Montreals. If you require the cap, please see MN138 If you require a washer bottle for a RHD car please see WI036 WASHER BOTTLE SPIDER S3 - 1984-89 & ALL RHD MONTREALS.

Correct profile Montreal door window channel felt. This section will do one door.  

Front quarterlight (triangle window) seal - right side.

Front quarterlight (triangle window) seal - left side.

Front windscreen seal for all Montreals.

Pair of headlight wiring grommets to fit into the rear of the headlight bowl on all 105 Series Spiders 1966-93 and all Step-front GTs. Can also be used in the outer headlight bowls on some 1750 2000 GTVs, GT Juniors and all Saloons. Suitable for...

Rear window hatch to body seal to suit Montreals. See item code MN021/1 for the inner rear window to frame seal.

Rubber seal with moulded corners to fit the rear window glass to the supporting frame. Two different types were fitted on Montreals throughout production. Please check your car carefully before ordering. Alternative style please see MN021/1 ...

A pair of seals (left and right) to fit between the lens and the light unit on all Montreals.

A pair of rubber seals (left and right) to fit between the tail light unit and the bodywork on all Montreals.

Rubber seal to fit the rear window glass to the supporting frame. Two different types were fitted on Montreals throughout production. Please check your car carefully before ordering. Alternative style please see MN021/2 See item...

 Pair of top quality correct pattern door seals to fit all Montreals.

Side window rubber/scraper to fit all Montreal doors. Sold in 1.3m lenghts. 

Rubber grommet for the inner guard/wing where the hydraulic brake pipe passes through the metalwork. Two required per car - one on each side. Also fit Montreal bonnet emergency release cable and the grommets for the headlight vacuum pipe.

Large rubber floor bung to fit into the pressing holes in the floor panel of all 105 Series cars. Also used in the spare wheel well too. Total 8 required for GTs, Saloons and Montreals and 6 required for Spiders. Also fits many 116 and 75 models...

Rubber gaiter that fits over the transmission tunnel aperture cover (that attaches to the transmission tunnel pressing) inside the cockpit of all 105 series Coupes, Saloons and Spiders. Is covered by the centre console in cars with the consoles fitted...

Circular rubber firewall grommet for the speedometer cable and some wiring on left hand drive Montreals.

Rubber plug/bung to fit all 105 Series Spider doors. Goes into the leading edge of the door to cover an access hole for a bolt on the quarterlight window frame. One used per door. Also fits Montreal doors.

Grommet for the heater hose where it passes through the firewall. Fits all 105 series cars from 1968 onwards plus many 116 and 75 models.. Two are required for right hand drive cars, one for left hand drive cars that use a different combined grommet for...

Two piece rubber grommet for the accelerator/throttle lever through where is passes through the bulkhead on all left hand drive cars.

Oval rubber grommet for where the main wiring loom passes from the cabin into the engine bay on all 105 series cars.