MONTREAL PARTS : BRAKES

New production - pair of rear brake calipers to fit all Montreals.

Vented front brake disc for Alfa Montreal. 

Vented rear brake disc for Alfa Montreal. 

New production - pair of front brake calipers to fit all Montreals. Also fits Ferrari 308 models as well! 

 Give Your brakes the highest possible guarantee with the NEW Brembo B-Quiet lubricant. B-Quiet is a new Brembo lubricant which provides long term high load capacity and reliability for your braking system.The brake lubricant should be applied where the...

  ATE brake cylinder paste is used for repair, assembly and conservation of hydraulic brake components, It is applied thinly and evenly to cylinder sleeves, pistons and seals. (Assembly of Brake calipers, Master cylinder etc). - ATE brake cylinder paste...

Set of Ferodo rear brake pads to fit all ATE braked 105 Series cars.

Set of Ferodo front brake pads to fit the larger ATE brake calipers used on 1750 & 2000 engined cars and Montreals. Also used on 1.6 Spider from 1985 onwards.

Front RIGHT brake flexi hose bracket. To fit all 105 Series cars & Montreals. NOT SUITABLE FOR DUNLOP BRAKES

Front LEFT brake flexi hose bracket. To fit all 105 Series cars & Montreals. NOT SUITABLE FOR DUNLOP BRAKES

Goodridge braided brake line set (complete car set – 3 pieces). These stainless steel brake flexi hoses will improve the pedal feel and are guaranteed for life. This version is approved by the German TUV authorities and therefore suitable for the...

Brake flexi hose for the rear of all 105 series cars including Montreals, as well as 750 and 101 Series cars. Goes from the body to the rear axle. ONE PER CAR! Will also fit the hydraulic clutch hose on 2600 (106) cars.

Brake flexi hose to fit the front brake system (between brake lines and calipers/drums) on all 105 Series cars including Montreals, as well as 750, 101 and 106 (2600) Series cars.

Short front copper brake pipe from the flexible line to the brake caliper on all Dunlop braked cars from 1964-66. 

Short front brake pipe from the flexible line to the brake caliper on ATE braked cars from 1968-93 with large front calipers (1750+2000 models) including Montreals. Please specify if you require copper or cupro-nickel pipe on your order.

Rubber grommet for the inner guard/wing where the hydraulic brake pipe passes through the metalwork. Two required per car - one on each side. Also fit Montreal bonnet emergency release cable and the grommets for the headlight vacuum pipe.

Rubber plug brake master cylinder, 15mm diameter. Used to connect the reservoir to the master cylinder. 

Rubber plug brake master cylinder, 20mm diameter. Used to connect the reservoir to the master cylinder. 

Bleed screw cap. Will fit all bleed screws.  

Brake disc/drum retaining screw.

Large sized brake caliper bleed screw to fit 1750/2000 ATE front brake calipers.

Small sized brake caliper bleed screw to fit 1300/1600 small ATE front brake calipers and all ATE rear brake calipers.  

Caliper seal kit to fit all ATE rear brake calipers - one kit does two calipers. Note, if you are splitting the caliper apart, this kit does not include the small internal 'O' rings in the calipers. These are sold separately under item code BR086. 2...

Caliper seal kit to fit all ATE front brake calipers - one kit does two calipers. Note, if you are splitting the caliper apart, this kit does not include the small internal 'O' rings in the calipers. These are sold separately under item code BR086. 2...