105 COUPE PARTS : CLEARANCE

22mm open wheel nut - right hand thread chromed. Classic Alfa production of these original style wheel nuts.

Brake fluid reservoir for left hand drive 105 series cars from 1970 with hanging pedals. Also fits some 116 models. 3 cap version. Also suitable for LHD Montreals. This reservoir is brand new. It is just missing one of the caps. As can be seen in...

Pair of polyurethane front anti-roll bar droplink bushes to suit early 105 series cars. These bushes are brand new. They are just not a production we usually sell.

Early style voltage regulator (Bosch) to suit all 105 series cars with dynamos/generators as well as 101 series cars as well. This regulator is brand new. It has just been slightly scratched up on delivery to us.

Front quarterlight / quarter window rubber seal to fit all 105 series GT, GTV, GTA & GTC cars - right hand side. This seal is brand new, it is just an old production that we no longer stock.

Right hand, bayonet/blade style wiper arm to fit all non step front GTs as well as Giulia Supers and Berlinas. Note, that if you are replacing an original style arm with the grey cap over the mounting nut, you will need a WI012 nut to fit this to...

Separate indicator repeater lights to suit all Step-front GTs. Also suits Giulia saloons which use the same repeator without the surrounding 'chrome' piece, which is available separately. This light unit is brand new, however it has some...

GT front right screen insert - nicely made anodised aluminium extruded section that fits into the screen rubber. This insert is brand new, we just usually sell them in match pairs. The finish on this part is also more matte than the usual shinier...

GT rear right screen insert - nicely made anodised aluminium extruded section that fits into the screen rubber. This insert is brand new, we just usually sell them in matched pairs.

New centre grille 'heart' to suit all Step-front GTs. 7 bar style as fitted to cars from Sprint GTV onwards, but will also fit Sprint GT models. New production - great fit. This unit is brand new, it just has a small manufacturing flaw, being a...

New fuel tank to fit all 105 Series Coupes except 2000 GTV from 1964-77 - with correct neck (23 cm long, 58mm diameter). This tank is brand new. It has been fitted and removed from a car so has some fitting marks and received some...

Pair of Weber 45 DCOE rampipes. These are brand new, they are just not a production we usually sell. Distance from flange to rolled opening - 3cm Total height - 6.7cm

Cloverleaf metal keyring. These keyrings are brand new we just don't usually sell this production.

Clutch master cylinder boot to fit Bonaldi master cylinders fitted to all 105 Series cars with standing pedals (LHD cars to about 1970 and all RHD cars). Will not fit ATE cylinders. This clutch boot is brand new, it is just not a production we usually...

Lightweight billet steel competition 6 bolt flywheel to suit 2000 competition engines using early mechanical clutch. This flywheel was used for Classic Alfa R&D and is therefore missing its ring gear which you can buy separately under the...

Beautifully made rear seat cover trim set to suit the rear seat of 1750 GTV Mk 2 models. This version is done in early Cinghiale brown vinyl as found in the earlier Mk 1 1750's. This is not the factory original style but is still a beautifully made piece.

Lightweight billet steel competition 6 bolt flywheel to suit 2000 competition engines using early mechanical clutch. 105 tooth ring gear, 200mm driven plate. Also suitable for using a later 6 bolt 1600 crank in an early engine. This flywheel...

Rear brake pads - set of 4 - to suit 105 cars with ATE brakes. These pads are brand new they are just not a brand we currently sell - ALA (made in italy)

Set of spare panels to suit Series 2 1750 GTV, 2000 GTV as well as GT Juniors from 1973 onwards. These are spare panels that we had left over, all of which are brand new. This set includes the 2 tunnel mats, the rear vertical mats &...

Rear seat base cover to fit GT Junior cars from 1969-72. Beautifully made in the correct black vinyl skai material with the correct pattern. This seat cover is brand new, we just usually sell the back with the base.

Beautifully made front seat cover back to suit 1750 GTV Mk 2 models. This cover is in late Cinghiale brown vinyl, made in the correct original style and pattern including the 'basketweave' style material on the back of the seat. This cover is brand...

GT front left bumper spacer as used on Mk 2 1750, 2000 GTVs and late GT Junior. Made in the original Bakelite material. This spacer is brand new we just usually sell them in pairs. STANDARD PRICE OF PAIR: £45.00 (EXC VAT)

Exhaust flexi joint for custom exhausts, this joint has an outer bore size of 50mm on one side and 54mm on the other.

Beautifully made inner door panels to suit GT Juniors from 1970 onwards. Done in the correct style and skai brown (Cinghiale) the type without the veins. Sold as a pair. If you also require rear panels please see IN265 Please note these panels...