105 SPIDER PARTS : CLEARANCE

Set of original AE pistons to suit a 2000 nord engine. This set is brand new and includes the rings and gudgeon pins. We just usually sell this set complete with liners.

OE piston and liner to suit 1300 nord engines. This piston an liner is brand new, however it is missing a gudgeon pin.

Original AE Borg/Goetze 2000 liner. This liner is brand new we just usually sell them as part of a full set. Inner Diameter - 84mm

25mm aluminium rear spring shim/spacer to fit all 105 Series Saloons, Coupes Spiders. Used to adjust the rear ride height on cars from the factory.

Gearbox/differential filler plug (shallow type) without the magnet. This filler plug is brand new. It is just not a production we usually sell.

Pininfarina pin/badge set. Comes with a small case as can be seen in the photos.

Alfa Romeo, lucky charms style keyring. Each of the three pendants can hold individual keys. Comes in lovely old carry case so would make a good gift.

22mm open wheel nut - right hand thread chromed. Classic Alfa production of these original style wheel nuts.

Pair of polyurethane front anti-roll bar droplink bushes to suit early 105 series cars. These bushes are brand new. They are just not a production we usually sell.

Pair of rubber seals that fit between the top of the front wings and the scuttle panel on Spiders. Originally fitted to later Series 3 and 4 Spiders, but can be fitted to any Series 2 car as well. These seals are brand new. They are just an old,...

Plastic "Spider" script for rear of Series 4 Spider 1990-93. Requires adhesive to fit. We recommend a decent automotive double sided tape, or specialist adhesive film to affix the badge to the car. This badge has broken into two parts, this would...

Left section for the spoiler/air dam found on Series 3 Spiders from 1985-89. This panel is brand new, it is just an old production we used to sell.

Coil to distributor high tension ignition lead to suit Series 4 Spider (and late fuel injected S3) 1988-1993 plus fuel injected 4 cylinder 75s. Brand new, just usually sold as a set.

Cylinder 4 high tension ignition lead to suit Series 4 Spider (and late fuel injected S3) 1988-1993 plus fuel injected 4 cylinder 75s. Brand new, just usually sold as a set.

Cylinder 3 high tension ignition lead to suit Series 4 Spider (and late fuel injected S3) 1988-1993 plus fuel injected 4 cylinder 75s. Brand new, just usually sold as a set.

Cylinder 2 high tension ignition lead to suit Series 4 Spider (and late fuel injected S3) 1988-1993 plus fuel injected 4 cylinder 75s. Brand new, just usually sold as a set.

Pair of Weber 45 DCOE rampipes. These are brand new, they are just not a production we usually sell. Distance from flange to rolled opening - 3cm Total height - 6.7cm

Cloverleaf metal keyring. These keyrings are brand new we just don't usually sell this production.

Lightweight billet steel competition 6 bolt flywheel to suit 2000 competition engines using early mechanical clutch. This flywheel was used for Classic Alfa R&D and is therefore missing its ring gear which you can buy separately under the...

Rear brake pads - set of 4 - to suit 105 cars with ATE brakes. These pads are brand new they are just not a brand we currently sell - ALA (made in italy)

Beautifully made right side inner door trim panel to suit Series 4 and some late 3 Spiders from 1989-93. Done in the correct style and skai black material and includes the heat pressed trim lines as well. This panel is brand new, we just...

Upper rear panel for all Kamm-tail Spiders 1970-83. Covers the area from the bumper up to the bootlid. Pressed from original Pininfarina tooling. This panel is brand new it is just not a production we usually sell.

Left trim panel that fit in the footwells of all Roundtail Spiders from 1966-70. These panels are brand new, they are just an old production that we usually sold in pairs. Vinyl wrapped around metal.

Exhaust flexi joint for custom exhausts, this joint has an outer bore size of 50mm on one side and 54mm on the other.