105 SPIDER PARTS : RUBBER

Here is a diagram showing the location of some of the parts in this category.

Here is a diagram showing the location of some of the parts in this category.

Here is a diagram showing the location of some of the parts in this category.

Here is a diagram showing the location of some of the parts in this category.

Here is a diagram showing the location of some of the parts in this category.

Headlight seal to fit all 105 Series Spiders 1966 - 93 without perspex headlight covers - such as Spider Junior and all USA models. Cars fitted with covers do not use a seal.

Pair of headlight wiring grommets to fit into the rear of the headlight bowl on all 105 Series Spiders 1966-93 and all Step-front GTs. Can also be used in the outer headlight bowls on some 1750 2000 GTVs, GT Juniors and all Saloons. Suitable for...

Replacement windscreen rubber to suit all 1966-70 Roundtail Spiders.

1970-93 Spider windscreen rubber.

1970-93 Spider boot/trunk lid rubber seal.

Bootlid/trunk seal to fit all Roundtail Spiders 1966-70

Rubber grommet for the firewall to suit left hand drive Spiders (and possibly Coupes Saloons) up to 1969. It is for the choke cable and hand throttle cable on these cars.

Rubber seal for all models of 105 Series Spiders 1966-1993, used where the scuttle panel attaches to the firewall.

Classic Alfa Production - The firewall/bulkhead cable grommet for speedo/tacho and the choke cables on all right hand drive Saloons, Spiders and GTs/GTVs. This grommet always needs renewing and was out of production and unavailable for over 20...

Classic Alfa production of the steering column grommet for most right hand drive 105 Series GT/GTVs, Saloons and Spiders. Previously unavailable for many years, this part has been in great demand by all 105 series restorers. Some later cars (1973...

Rubber grommet for where the steering column passes through the firewall on left hand drive 105 Series cars 1971 - 1989 with hanging pedals.

Rubber grommet for where the steering column passes through the firewall on left hand drive 105 series cars up to 1970 with standing pedals.

Engine bay bulkhead grommet for the wiring harness on Spider Series 4 (1990-93)

Rubber seal that fits between the top of the left front wing and the scuttle panel on Spiders. Originally fitted to later Series 3 and 4 Spiders, but can be fitted to any Series 2 car as well. See item code RB078/1 for the same part for the right hand...

Rubber seal that fits between the top of the right front wing and the scuttle panel on Spiders. Originally fitted to later Series 3 and 4 Spiders, but can be fitted to any Series 2 car as well. See item code RB078 for the same part for the left hand side...

Rubber gaiter that fits over the transmission tunnel aperture cover (that attaches to the transmission tunnel pressing) inside the cockpit of all 105 series Coupes, Saloons and Spiders. Is covered by the centre console in cars with the...

Large rubber seal/gasket that fits between the transmission tunnel pressing and the transmission tunnel apeture cover (either metal or plastic/foam versions) on most of the 105 series range. Fitted to Sprint GT, GTV, GTC GTA models, all Roundtail...

Spider Quarterlight top finishing rubber for cars from 1970 on. May also fit Roundtail cars, but is not quite correct style. Fits both sides of the car.

Small front door seal for all 105/115 Series Spiders 1966 - 1993. This one is for the left door - looking from the rear of the car. See RB045/1 for the right hand door seal. Also available are the rear door seal - see Code RB046 (left) and...