105 SPIDER PARTS : RUBBER

Rubber seal that fits between the top of the left front wing and the scuttle panel on Spiders. Originally fitted to later Series 3 and 4 Spiders, but can be fitted to any Series 2 car as well. See item code RB078/1 for the same part for the right hand...

130mm Romablok clamp to be fitted around the outer gearbox rubber gaiter GB021.

90mm Romablok clamp to be fitted around the inner gearbox rubber gaiter GB020.

Rubber grommet for the inner guard/wing where the hydraulic brake pipe passes through the metalwork. Two required per car - one on each side. Also fit Montreal bonnet emergency release cable and the grommets for the headlight vacuum pipe.

Large rubber seal/gasket that fits between the transmission tunnel pressing and the transmission tunnel aperture cover on 105 series cars with a metal aperture cover. May also be used on some 750 and 101 series cars as well. ** NOTE ** - Cars with...

Small rear of door seal for all 105/115 Series Spiders 1966 - 1993.  This one is for the right side door - looking from the rear of the car. See RB046 for the small seal for the left hand door. Also available are the small front of door seals - see Code...

Small front door seal for all 105/115 Series Spiders 1966 - 1993. This one is for the right side door - looking from the rear of the car. See RB045 for the left hand door seal. Also available are the rear door seal - see Code RB046...

Vertical door glass channel felt to fit the front of the door glass in all Spiders. 2 required per car.

Vertical door glass channel felt to fit the rear of the glass in all Spiders. 2 required per car.

Small rear of door seal for all 105/115 Series Spiders 1966 - 1993.  This one is for the left door - looking from the rear of the car. See RB046/1 for the small seal for the right hand door. Also available are the small front of door seals - see Code...

Small front door seal for all 105/115 Series Spiders 1966 - 1993. This one is for the left door - looking from the rear of the car. See RB045/1 for the right hand door seal. Also available are the rear door seal - see Code RB046 (left) and...

Spider Quarterlight top finishing rubber for cars from 1970 on. May also fit Roundtail cars, but is not quite correct style. Fits both sides of the car.

Bonnet/hood stop for all Coupes and Spiders - Coupes use two per car, Spiders use six per car. Also can be trimmed down and used as the rubber stop for the boot/trunk lid on all Kammtail Spiders.

Large rubber floor bung to fit into the pressing holes in the floor panel of all 105 Series cars. Also used in the spare wheel well too. Total 8 required for GTs, Saloons and Montreals and 6 required for Spiders. Also fits many 116 and 75 models...

Rubber gaiter that fits over the transmission tunnel aperture cover (that attaches to the transmission tunnel pressing) inside the cockpit of all 105 series Coupes, Saloons and Spiders. Is covered by the centre console in cars with the...

Rubber seal for the end of the windscreen base trim (right side) as originally fitted to Series 3 and Series 4 Spiders. Can also be fitted to Series 2 cars.

Rubber seal for the end of the windscreen base trim (left side) as originally fitted to Series 3 and Series 4 Spiders. Can also be fitted to Series 2 cars.

The small plastic rivet that retains the top of door rain seals on all Spiders. One rivet is used on the rear of door glass seal (available under codes RB046 & RB046/1) and two on the front of door rain seal on each door (codes RB045 &...

This door seal is equivalent to RB022 but sold by the metre.

Rubber seal with a flocked/velour edge. Sold by the metre. This door seal is equivalent to RB024 but sold by the metre.

Rubber seal in the correct style for all Spiders 1970-93 - with a flocked/velour edge. 2 required per car. See item RB022 for the matching seal for Roundtail Spiders. Also see item RB023 for the door seal end plugs to suit these seals.

Spider door seal end plug. Use to tidy up the appearance of the end of the door seals (either item code RB022 or RB024) when fitted to all model Spiders 1966-93. 4 required for each car.

Main door seal in original style (non-flocked) for all Roundtail Spiders. Will also fit later Spiders 1970-93, but not exactly in the original style. See item RB024 for original style seal for Spiders 1970 onwards. Two required per car. See also RB023...

Engine bay wiring grommet clamp, fitted to alll 105 cars. The rubber grommet is available under our part number RB054. Also fits 102 and 106 models.