105 SALOON PARTS : CLEARANCE

22mm open wheel nut - right hand thread chromed. Classic Alfa production of these original style wheel nuts.

Brake fluid reservoir for left hand drive 105 series cars from 1970 with hanging pedals. Also fits some 116 models. 3 cap version. Also suitable for LHD Montreals. This reservoir is brand new. It is just missing one of the caps. As can be seen in...

Pair of polyurethane front anti-roll bar droplink bushes to suit early 105 series cars. These bushes are brand new. They are just not a production we usually sell.

Early style voltage regulator (Bosch) to suit all 105 series cars with dynamos/generators as well as 101 series cars as well. This regulator is brand new. It has just been slightly scratched up on delivery to us.

Right hand, bayonet/blade style wiper arm to fit all non step front GTs as well as Giulia Supers and Berlinas. Note, that if you are replacing an original style arm with the grey cap over the mounting nut, you will need a WI012 nut to fit this to...

Separate indicator repeater lights to suit all Step-front GTs. Also suits Giulia saloons which use the same repeator without the surrounding 'chrome' piece, which is available separately. This light unit is brand new, however it has some...

105.49 body type plate to fit a 1750 Berlina Gd e CKD (RHD South African Berlinas). This plate is brand new. It is just not one we usually sell.

Pair of Weber 45 DCOE rampipes. These are brand new, they are just not a production we usually sell. Distance from flange to rolled opening - 3cm Total height - 6.7cm

Cloverleaf metal keyring. These keyrings are brand new we just don't usually sell this production.

Clutch master cylinder boot to fit Bonaldi master cylinders fitted to all 105 Series cars with standing pedals (LHD cars to about 1970 and all RHD cars). Will not fit ATE cylinders. This clutch boot is brand new, it is just not a production we usually...

Lightweight billet steel competition 6 bolt flywheel to suit 2000 competition engines using early mechanical clutch. This flywheel was used for Classic Alfa R&D and is therefore missing its ring gear which you can buy separately under the...

Lightweight billet steel competition 6 bolt flywheel to suit 2000 competition engines using early mechanical clutch. 105 tooth ring gear, 200mm driven plate. Also suitable for using a later 6 bolt 1600 crank in an early engine. This flywheel...

Rear brake pads - set of 4 - to suit 105 cars with ATE brakes. These pads are brand new they are just not a brand we currently sell - ALA (made in italy)

Left Inner headlamp (5 3/4") mounting frame for 4 headlight Giulia saloon. This headlamp frame is brand new it is just missing the plastic fittings we usually sell with the frame. You can purchase 2 of the 3 fittings individually under the code...

Exhaust flexi joint for custom exhausts, this joint has an outer bore size of 50mm on one side and 54mm on the other.

Full set of seat covers in red vinyl to suit late Giulia Saloons. Produced in the correct style and original material. There is nothing wrong with these seat covers, they were just a special order that were uneeded.

Giulia saloon rear inner door panel pair in black, to suit cars made between 1962-73. This is the rear pair only, this pair has a slightly offset heat stitch pattern from left to right as can be seen in the photos. this will barely be noticeable once...

Original equipment Sachs clutch frction plate to fit all 105/115 Series cars 1968 onwards. This friction plate is brand new, it is just the last one of an old production we no longer sell.