105 SPIDER PARTS : OTHER RUBBER PARTS

Soft-top front rubber seal to suit all Spriders 1970-93. Fits in channel (available under code RB028) that is attached to the header rail of the soft-top and seals against the top of the windscreen.

Get the rubber pedal base seal & the metal retaining bracket (to suit all right hand drive 105 series cars with floor hinged pedals) RB066 and RB067 together for a better price!

Metal pedal base seal bracket to retain the rubber seal available under code RB066 on all right hand drive 105 Series cars.  Note that this bracket will require some 'relieving' on the inner left side to fit properly to the car. It's much better that the...

Right hand drive pedal base seal - for all rhd cars from 1964 to 1978. To properly fit the boot, the pedal box must be removed from the car and the pedal shafts removed from the pivot. The boot is fitted by inserting the shaft of the pedal through from...

Rear window hardtop seal to fit Kammtail Spider. Please look at the pictures before ordering, to make sure you are ordering the correct seal.

Rubber seal for the rear edge/base of the factory hardtop for Kammtail Spiders. Please check that the profile resembles your old seal as there is more than one type of hardtop fitted to these cars.

Rubber seal for the rear edge/base of the factory hardtop for all Roundtail Spiders 1966-69

Rear window hardtop seal to fit Roundtail Spider. See also item RB033 for the side window seals to suit as well. Please look at the pictures before ordering. This seal is for the hardtop with three windows.

Pair of side door window seals to suit a hardtop for a Roundtail (1966-69) Spider. See RB033/1 for a rear window seal for a hardtop as well.

Front rubber seal to fit the original style hardtop on all Kammtail Spiders

Rubber spacer/mounting block for the front bumper to nose panel on Spiders 1986-93. 6 required in total per car.

Front rubber seal to fit the original style hardtop on all Roundtail Spiders 1966-69

Pair of side window seals to fit all hardtops on Spiders 1970-88.

Pair of rubber sections to fit into the rear bumper over riders on all Roundtail Spiders 1966-70.

Soft top channel drain hose to suit 105 Spiders from 1970-93. This is the hose that runs down the B-post to the sill for drainage of the soft top channel. *Please note this hose will do both sides. It just needs to be cut in half and then trimmed to...

Spider 105 drain water hose around soft top/hood, 1970-93 cars. This hose is located on the rear section of the car, see pictures. Two required per car.

Fuel flap seal for all Spiders from 1966 to 1993.

Fuel filler neck seal Spider

Comprehensive set of rubber seals for all Kammtail Spiders, consisting of: RB011 - Door glass felt x2 RB021 - Windscreen rubber RB022 - Main door seal x2 RB023 - Main door seal end plug x4 RB025 - Left quarterlight seal RB026...

Comprehensive set of rubber seals for all Roundtail Spiders, consisting of: RB011 - Door glass felt x2 RB020 - Windscreen rubber RB022 - Main door seal x2 RB023 - Main door seal end plug x4 RB030 - Bootlid seal RB031 - Soft-top front...

Rubber gasket that fits under the hardtop chrome strip on the right rear deck of all Spiders 1970-93.

Rubber gasket that fits under the hardtop chrome strip on the left rear deck of all Spiders 1970-93.

Pair GT bootlid hinge buffers that prevent the bootlid/trunk lid opening too far on your GT/GTV and damaging the bodywork. Note that some early Stepfront cars have four buffers fitted, while later cars use two located inside the 'loop' of the hinge. Also...

Protection cover for the fuel tank sender. Will fit all 105 Series cars. Please note this is made of black rubber, whereas the original type was made of a dense foam material and had an internal metal spine.