105 SALOON PARTS - FUEL - OTHER FUEL SYSTEM PARTS - Page 3

FL022 INLET MANIFOLD GASKET 105, 116, 75 NORD

Inlet manifold gasket to fit all twin carburettor 105 series cars and Spica equipped models. Plus 116 and 75 models with carburettors (excluding V6 and TS). For early single carburettor cars see code FL022/1 and for later Fuel Injected cars see FL039...

£5.50

FL051/2 VERTICAL THROTTLE ROD - 97mm

Short vertical throttle rod (approx 97mm between centres) that fits between the carburettors on some Left Hand Drive 1750 and 2000 model 105 Series cars - and possibly some other versions too. Includes metal ends and spring retaining clips. Note that RHD...

£20.00

FL051/1 SHORT VERTICAL THROTTLE ROD - 45mm

Short vertical throttle rod (central aduster threaded rod is 45mm) that fits between the carburettors on twin carburettor 101 and 105 series cars. Includes metal ends and spring retaining clips. Note that this will fit right hand drive cars and some left...

£19.50

FL050 METAL THROTTLE ROD END

Metal throttle rod end - use with new adjustable throttle rod - 2 required per rod.

£2.95

FL052/2 BALL JOINT THROTTLE LINKAGE.

Ball joint, for the throttle linkage, works in conjunction with FL052/1.

£5.70

FL052/1 THROTTLE LINKAGE ROUND BUSH

Bush for the throttle linkage mechanism arm. Also used on the clutch pivot arm on mechanical clutches.

£4.40

FL052 THROTTLE LINKAGE SUPPORT D-BUSH

Bush for the throttle linkage mechanism where it pivots on the firewall/bulkhead. Two required per car.

£3.30

FL087 ACCELERATOR RETURN SPRING ALL 105 MODELS

Accelerator return spring to suit all 105 model, GT Bertone, Spider and Giulia. Right or left hand drive.

£5.00

FL051 ADJUSTABLE MAIN THROTTLE ROD

Adjustable throttle rod. Replace your old worn out horizontal plastic rod and make sure you are getting full throttle travel! Vertical rod also available - see item code FL051/1 Metal ends available separately under code FL050.

£16.95

FL024/1 AIRFLOW TESTER ADAPTOR ELBOW FOR SIDED…

Adaptor elbow to enable you to use the Airflow Tester (available under item code FL024) more easily on sidedraft carburett

£17.50

FL024 SCHLEYER CARBURETTOR AIRFLOW TESTER/SYNC…

Schleyer carburettor airflow tester/synchrometer - used to check the airflow through each carburettor to assist you in balance the flow across multiple carburettors. Use in conjunction with the adaptor elbow under available under item code FL024/1 which...

£47.50

FL033 HOT AIR DUCTING TUBE - AIR INTAKE

Hot air ducting tube (60mm diameter) to suit all 105 series cars from 1970 on with the 'warm air' intake panel located on the side of the engine block. This tube goes from the air cleaner to the plate.

£12.00